Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
01-08-2002, 02:56 PM
|
#1 |
|
Registered Member
Join Date: Jan 2002
Posts: 3
|
Thanks for the info...good to know. I did find the problem. I had marked the spot the roll pin had been drilled in and put the new hole at right angles to it. After more examination the other day I realized that the new hole and the line from the old hole were in line with each other....the roll pin had sheared. Cleaned everything out, installed a new roll pin and everything's been fine since.
 Last edited by fxbill; 01-08-2002 at 03:23 PM.. |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| building a stroker need advice on solid roller or hydrallic roller cam ?? | Mustangboy89 | Windsor Power | 4 | 06-06-2003 02:10 PM |
| Solid Roller ? | STROKER BILLY | Windsor Power | 5 | 11-19-2002 12:04 AM |
| 351W roller conversion | Capri306 | Windsor Power | 4 | 02-14-2002 04:49 PM |
| hydraulic roller valvetrain for HP street?? | Stang_ROTY | Windsor Power | 2 | 04-27-2001 01:09 AM |
| Non roller to roller 351 block ????? | 88workcar | Windsor Power | 2 | 03-04-2001 12:45 PM |