Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
01-30-2002, 07:28 PM
|
#1 |
|
Registered Member
Join Date: Jan 2002
Location: Houston, Tx
Posts: 15
|
spacer
I agree that the EGR port should be blocked before adding a spacer. However, you should consider *why* you are adding a spacer. It will keep the air cooler but it also adds length to your runner as previously mentioned in this thread. If you are planning on a spacer and nothing else then realize that there is no gain whatsoever by that add on alone. for example, i added rollerrockers and taller valve covers, as well as an upper intake from an explorer. I *HAD* to get a 1" spacer just to fit it all together. I hope that helps.
__________________
87 DropTop NA (Project Sleeper 12.8) BBK Shorty Headers, 2 chamber FlowMasters dumped at axle. 3.73 gear, Crank Pully, 1.7 RollerRockers, MSD Blaster Kit 9MM wireset, ported upper and lower, blocked EGR port. 65MM EGR plate and TB, k&N filtercharger, Electric fan, Homespun ramair, ratio eprom, 24# injectors, 1" phenolic plenum spacer, FR Fuel pump, 15 deg TDC Best 12.886 @ 108.56 |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1 inch spacer? | 420nitro | Windsor Power | 0 | 02-08-2004 12:09 PM |
| are mac's 3 1/2 inch tail pipes for my setup | Chevysucks | Windsor Power | 1 | 03-18-2002 03:46 PM |
| carb spacer | hippi97 | Racer's Club House | 4 | 08-11-2001 12:10 PM |
| will the tall motorsport valve covers fit with a 3/8 inch spacer | Brian88 | Windsor Power | 3 | 07-31-2001 11:56 AM |
| carb spacer | hippi97 | Windsor Power | 2 | 05-18-2001 05:55 PM |