Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-07-2002, 07:02 PM
|
#2 |
|
Registered Member
Join Date: Feb 2000
Location: Newnan, GA, UnitedStates
Posts: 83
|
Ive got 1.7s pedestal mount and the E-cam and there are no clearance issues.From what Ive heard the 1.7s just make the cam seem a little more lumpy,compared to the 1.6s.I would definetly degree the cam to get the most out if it though.
__________________
92LX 5.0 Hatch,4.10 gears Auburn Pro,Mosser axels,alum drive shaft AOD hi ratio gear set,3200 stall TCI conv,Bassani long tube headers/cats,2 chamber flow masters,2.5inch exhaust,331 stroker,alum GT40 heads ported,Omega 1.7 roller rockers,JE forged pistons,Eagle rods,E cam,GT40 upper/lower intake,70mm mass,73mm Pro M bullet,MSD ignition,Cartech fuel sys w/external Aeromotive fuel pump,30lb injectors,Vortech S trim,Tubular front end,D&D coil overs up front |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dont use 1.7 rockers with stock heads? | Coupe5oh | Windsor Power | 10 | 11-28-2015 12:36 PM |
| Noise rockers Help?????? | 393Clevor | Windsor Power | 5 | 07-21-2003 06:44 AM |
| Rail Rockers on 289 Small Block Heads | sleeperstang | Classic Mustangs | 16 | 05-11-2003 11:34 PM |
| Roller Rockers, bad? | HiFlow5 0 | Windsor Power | 1 | 04-14-2002 01:35 PM |
| reg rockers or roller rockers?? | Chevysucks | Windsor Power | 1 | 12-05-2001 08:17 PM |