Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
03-12-2002, 02:01 PM
|
#1 |
|
Registered Member
Join Date: Aug 2000
Location: Wisconsin
Posts: 879
|
YES! definitly use guide pins...i didnt and the passanger side gasket slide..leting antifreeze into the cylinder....got about half a block and it water locked....trust me..it sucks really bad...to have antifreeze pouring out your exhaust.....nope nope..you definitly dont want a V8 water pump
__________________
'91 GT,410W,10.5 to 1 comp,Victor Jr. heads,Victor 5.8 intake,FTI cam,Crane retro fit lifters,Scorpian 1.6 RR's,Melling HV oil pump,MSD distro.,Canton oil pan,FMS flywheel,Romac balancer,FMS timing chain,Accufab 90mm TB,C&L 76mm maf, 42lbers,HD clutch,K&N air filter,Mac long tubes,Pro dumps,powerchamber,FMS 9mm wires,180 thermostat,Ford Racing gauges,5inch Tach,centerline convo pro's,nitto DR's,Pro3i lower control arms,50/50 shocks,3.55 gears,TFS HD diff. cover Next year: Tremec TKO,Spec stage 3 clutch,alum driveshaft,complete fuel system www.angelfire.com/linux/demondan |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Edelbrock RPM intake install problems | jruppert | Windsor Power | 4 | 03-04-2004 05:05 PM |
| Trick Flow intake problems | shacar87 | Windsor Power | 9 | 11-14-2003 05:53 PM |
| Cobra Intake? | 95mustanggt | Windsor Power | 5 | 10-01-2002 09:55 AM |
| upper intake and egr spacer install..... | scale | Windsor Power | 3 | 08-18-2002 11:37 PM |
| new coolant leak after intake install | fiveohpatrol | Windsor Power | 15 | 03-04-2001 09:15 PM |