Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-13-2002, 03:04 PM
|
#7 |
|
Registered Member
Join Date: Nov 2001
Location: germantown MD
Posts: 283
|
Well I used a wire brush on a drill to get the deck perfectly clean. I had a chicken and egg problem. I did head gaskets before and then water pump and I think I am going to do head just one more time. I am going to get the heads checked again and I guess I'll get the intake checked also just to be sure. But It would make it a much bigger job, as I don't plan on taking the block out of the car to do this, if something is wrong with the block.
__________________
85 GT 4bbl roller cam 2 ch. Flowmasters, O/R H-pipe Performer intake and carb milodon water pump, FMS 9mm wires, aluminum driveshaft, king cobra clutch |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Classic Mustangs | 8 | 06-16-2005 11:43 AM |
| Need opinions. Intro to the Sci Fi story I'm writing. LONG | Mercury | Blue Oval Lounge | 11 | 06-25-2001 08:35 AM |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Small Ponies | 0 | 05-12-1999 02:27 AM |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Racer's Club House | 0 | 05-12-1999 02:27 AM |