Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-02-2002, 11:16 AM
|
#4 |
|
Moderator
Join Date: Dec 1999
Location: Livonia, MI, USA
Posts: 1,194
|
I did my own cage...
...but I also just welded in an Autopower in a 2000 Cobra for someone. I like that bar in that it was curved behind seats, to allow lots of driver leg-length. Granted it was only a 4-point, but you could add on some front supports fairly easily. Too bad I never took pictures. Will have to get some at the next opentrack event WE will both be attending.
__________________
Darius Rudis, Moderator Corner Carvers Delight 1989 Mustang LX - Open Track Car http://www.dariusrudis.com |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 8-point competition engineering roll cage | Dog5ohfun | Windsor Power | 3 | 02-23-2004 01:34 AM |
| Questions on Roll Cages, Welding, and Ignition | BlackFireN2O | Windsor Power | 3 | 08-25-2002 08:01 AM |
| Quick Question about Roll Cage/Race seat compatibility | Fox Body | Windsor Power | 4 | 03-15-2002 01:16 PM |
| Gathering info on roll cage installation. | Fox Body | Windsor Power | 5 | 02-25-2002 11:35 PM |
| Roll Bar for a vert? | Chipdog | Windsor Power | 7 | 10-16-2001 05:07 PM |