Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
04-13-2002, 02:29 AM
|
#1 |
|
Registered Member
Join Date: Feb 2002
Location: Nebraska
Posts: 86
|
almost any aftermarket will do you good
The stock 5.0 control arms as you may know are a hollow design. This makes for a smooth ride, but no good for traction, because they twist under load. Any aftermarket control arm is better than the stock design for traction.
__________________
Proud RHC member #99 1990 Mustang GT Trick Flow heads,F303,Mac cold air,FMS 65mm tb,73mm ma,FMS 1.6,GT-40 intake,MSD igintion,NOS Big Shot@150,Mac equal shorties,Mac h-pipe,American Thunder flows,Centerforce dual friction,TTC 3550,alm drive shaft, 3.73's, HPM subframes, k-member brace, strut tower brace.. amongst others. |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What brand Control arms are good for 94GT | NYC1 | Windsor Power | 7 | 11-14-2002 07:39 PM |
| granatelli lower control arms are junk! | sn95gt19 | Windsor Power | 9 | 07-02-2002 09:37 AM |
| Rear lower control arms | explicitone | Windsor Power | 5 | 04-24-2002 11:49 AM |
| control arms | waldoo28 | Modular Madness | 2 | 01-24-2001 02:15 PM |
| Rear upper control arms | red82gt | Corner Carvers Delight | 2 | 08-01-2000 11:10 AM |