Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-01-2002, 02:19 AM
|
#4 |
|
Registered Member
Join Date: Aug 2001
Location: Ft. Worth, TX
Posts: 456
|
Get the O/R pipe into the hangers and EGR tube first then support the back of the pipe with a spare jack(hopefully you aren't using your jack while doing this install!) Place the jack under the crossover pipe. Jack it up level with the flow tubes going to the mufflers. Bolt up the pipe to the headers and then to the flowtubes. You can install the O2 sensors after you are finished if you don't want to risk breaking them. It is pretty easy, but it takes some patience if you are doing it by yourself.
__________________
You're gonna need your seatbelt |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| eibach advice needed | mustardjohn | Small Ponies | 6 | 08-19-2012 08:12 PM |
| HP guestimates needed for my new ride | Tod | Blue Oval Lounge | 6 | 10-15-2002 06:49 PM |
| Is chip needed when changing to 3.73's? | bark3rd | Modular Madness | 11 | 04-05-2001 11:21 AM |