Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-09-2002, 04:02 PM
|
#17 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
I am def going to check the PTVC when I am assebling my engine. I am going to use a solid roller the same size as the hydrolic one to make sure I get an accurate reading. Thanks for the advice
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Edel. non-smog to AFR smog legal heads? What do you guys think? | Simi Stang | Windsor Power | 10 | 06-19-2003 11:14 PM |
| Cylinder heads for blown 331 | Dave_mustang_50 | Windsor Power | 7 | 06-18-2003 03:45 PM |
| Best Cylinder Heads? | canary94 | Windsor Power | 7 | 03-31-2002 01:35 PM |
| For whoever it was considering using stock ported heads | 2FastLX | Windsor Power | 5 | 10-11-2001 01:53 PM |
| E7 cylinder heads | 89LXNB | Windsor Power | 2 | 01-02-2001 11:41 PM |