© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-28-2002, 11:05 PM | #1 |
Registered Member
Join Date: May 2002
Location: New Jersey
Posts: 375
|
Port matching throttle body to intake
Okay, so tomorw on goes a 76mm mass air and a 65mm throttle body. I couldn't get a hold of an egr spacer plate so I'm planning on just honing out the stock one and bolting it up. My question is, how hard is it to port match the intake to the 65mm throttle body. I have a little experiencee with machining but I'm still not really comfortable with it. Should this be taken to a machine shop and if i can do it at home, what should be done. I mean sure i can make the opening 65mm, but how do you match it to the runners? Chances are im gonna have to take it to a machine shop and be raped out the *** for the price.
__________________
'89 LX 5.0, off-road h pipe, flowmaster muffs, underdrive pulleys, rebuilt WC T-5, King Cobra Clutch, 65mm throttle body, Explorer Upper/GT40 lower, Lakewood Rear Lift Bars. 76mm C&L Mass air w/ inlet pipe, Twisted wedge heads w/ stage 2 port,polish, MAC equal length shorties, Billet AFPR, 255LPH fuel pump, fresh low end w/ 10.5:1 compression. If anyone ever wants to go to Raceway Park in Englishtown New Jersey, give me a shout. RICER HATERS CLUB MEMBER 87! www.ricehatersclub.com |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Will A Throttle Body Do Much For Ya With Minor Mods? | steedamustang01 | Modular Madness | 15 | 04-15-2002 10:38 PM |
what size throttle body | nextime | Windsor Power | 7 | 03-24-2002 09:53 PM |
Throttle Body for '96 | 84Stang | Modular Madness | 3 | 08-21-2001 05:59 PM |
Machining on a stock throttle body - can it be done?? | 2FastLX | Windsor Power | 5 | 03-29-2001 10:34 AM |
Stock intake, mass air, and throttle body | rtz | Windsor Power | 2 | 02-25-2001 11:00 PM |