MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Register FAQ Members List Calendar

Notices


 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old 07-30-2002, 12:45 PM   #20
Mach 1
Registered Member
 
Mach 1's Avatar
 
Join Date: May 1999
Location: Georgia
Posts: 3,866
Default

Quote:
Originally posted by 93GTDIN
If 4.10's may cause a stock car to run out of steam in the top end, would I have that problem? My combo makes peak power from 4500 - 6000 rpms.

Also, what is the bottom line as far as ET improvements that gears offer? Will I actually pick up anything or will the car just feel faster?

Another question. WIth the 4.10's, I wont hit OD before I finish the quarter will I?
Sounds like 4.10s are perfect for your car. You should see a couple tenths E/T improvement with gears. You wont hit OD because you will have your shifter in the D position, thus holding third gear. This will vary depending on tranny modifications.

If your trap RPM is to high that you run out of motor with the 4.10s by the end of the quarter in third gear, adjust the rear tire size to fine tune.
__________________
2002 GT
1993 GT (SOLD)
'93 Mustang GT
RHC member #142
Mach 1 is offline   Reply With Quote
 



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Leather Seats - Fronts & Gears MadOnion Windsor Power 3 06-06-2003 06:15 AM
Gears Gears Gears!!!! COBRAon18s Modular Madness 20 05-13-2002 04:44 PM
how can you tell what size gears you have? Kamaro Killer Windsor Power 7 04-03-2002 02:55 PM
Gears, need help!!!! Edgar Negron Windsor Power 3 05-27-2001 03:10 PM
Gears Gears Gears Skyman Windsor Power 6 03-11-2001 11:39 PM


All times are GMT -5. The time now is 04:13 AM.


SEARCH