Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-31-2001, 12:08 AM
|
#2 |
|
Registered Member
Join Date: Jun 2000
Location: ventura,CA
Posts: 438
|
I'm not sure on your specifics but make sure your distributor drive is made of steel. 85 and later cams had steel drive gears and earlier ford distributors didn't. It will fit right in but it will get eaten up quickly.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What all do you need to do rear disc conversion w/ SN95 Parts | KG88GT | Windsor Power | 1 | 07-29-2003 01:45 PM |
| questions about maf conversion | spankaveli | Windsor Power | 10 | 10-19-2002 02:46 PM |
| electronic turbo kit | chiaronate | Windsor Power | 1 | 07-09-2002 01:54 PM |
| mass air 87GT conversion | greydan | Windsor Power | 3 | 01-02-2002 07:57 PM |
| points and timing specs | xfernal | Classic Mustangs | 1 | 12-30-2001 04:20 PM |