Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-14-2002, 07:50 PM
|
#1 |
|
Registered Member
Join Date: Aug 2000
Location: Wisconsin
Posts: 879
|
rearend binding up
i just re installed my rear end back in my car. i know your suppose to jack the back end up BEFORE tightening the bolts..and i did jack it up i dont think it was enough..now when i back up then stop it creecks....can i just jack the back end up loosen the bolts then re tighten them??
__________________
'91 GT,410W,10.5 to 1 comp,Victor Jr. heads,Victor 5.8 intake,FTI cam,Crane retro fit lifters,Scorpian 1.6 RR's,Melling HV oil pump,MSD distro.,Canton oil pan,FMS flywheel,Romac balancer,FMS timing chain,Accufab 90mm TB,C&L 76mm maf, 42lbers,HD clutch,K&N air filter,Mac long tubes,Pro dumps,powerchamber,FMS 9mm wires,180 thermostat,Ford Racing gauges,5inch Tach,centerline convo pro's,nitto DR's,Pro3i lower control arms,50/50 shocks,3.55 gears,TFS HD diff. cover Next year: Tremec TKO,Spec stage 3 clutch,alum driveshaft,complete fuel system www.angelfire.com/linux/demondan |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| The LSC rearend swap | Nitrous Al | Windsor Power | 3 | 11-18-2001 07:29 PM |
| The Ford Sterling 10.25" rearend | Nitrous Al | Built Ford Tough | 4 | 09-06-2001 08:59 PM |
| play in the rearend? | HKstang | Windsor Power | 1 | 07-18-2001 12:02 AM |
| REAREND IDN. | POSCIVIC408 | Classic Mustangs | 3 | 04-08-2001 11:46 AM |
| Rearend swap | H'YAMULE | Classic Mustangs | 0 | 02-19-2001 09:48 AM |