© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-10-2001, 01:09 AM | #1 |
Registered Member
Join Date: Jun 2001
Location: coweta OK USA
Posts: 93
|
this one is for the top mechanics
i just bought a New High performance AODE Called the AODE INTERCEPTER, (off of transmissioncenter.net) and i had it Installed at a transmission shop, It drives and shift great, But when I give full throtle around 30mph It just revs up to 5grand then shifts It neutrals out, SO the tranny shop changed the Lever position Sensor. TPS Sensor, still nothing , so I sent the tranny back and got another one just in case it was a bad tranny but we got the same thing , I can't figure it out, Someone told me It might be the Vehicle Speed Sensor, Please Help
|
06-10-2001, 01:46 AM | #2 |
Registered Member
Join Date: Sep 2000
Location: Fresno,CA. USA
Posts: 384
|
If it's not stock geared you can have problems.
I'm not sure which point the computer will not work right. You might need 4.10's for a problem, or even 2 gear sets up from stock. But that could be it. ------------------ 4.10's,long tubes & 75 shot...Goes 12.50's Check it out at http://www.burnouts.stangnet.com 11's coming soon!!!! Heads,intake and cam are all here |
06-10-2001, 02:33 AM | #3 |
Registered Member
Join Date: Jun 2001
Location: coweta OK USA
Posts: 93
|
I have 3:73 gears. I got a custom chip from superchips, for that reason,
|
06-10-2001, 12:05 PM | #4 |
Registered Member
Join Date: Jan 2001
Location: Moline Il
Posts: 901
|
Did the transmission shop scan your car, or were they just guessing when they changed the mlps and tps? ACT, ACC, BOO, ECT, MAF, MLPS, OSS, TOT, TPS, and VSS are all sensors that have input signals to the transmission. What convertor are you using? Is it a lockup or non-lockup? Does your chip take the lockup out, or does it leave it alone? I dont understand the part about your chip having something to do with your gear selection. You do have a VSS with a plastic gear on it, dont you?
|
06-10-2001, 02:10 PM | #5 |
Registered Member
Join Date: Jun 2001
Location: coweta OK USA
Posts: 93
|
they scanned it and the MLPS came up and the voltage was off so the changed the TPS. I think its a non-lock up and I saw this off of a level ten add in a magazine it said if you have 3:73 or higher you must reprogram your computer or the tranmission will not work right. so i bought a SUPERCHIP , (it seems that the chip didn't work) will that hypertech reprogrammer reset my gear ratio
|
06-10-2001, 03:03 PM | #6 |
Registered Member
Join Date: Jan 2001
Location: Moline Il
Posts: 901
|
I'm thinking that the 95 should be the same as my 94. Maybe not though. All I had to do to correct my speedometer, was get the correct driven gear. Did your speedometer seem like it was close? If the VSS was at fault, it would have given a code as well.
|
06-10-2001, 03:14 PM | #7 |
Registered Member
Join Date: Jun 2001
Location: coweta OK USA
Posts: 93
|
MY SPEEDOMETER IS 6 mph OFF, DID YOU HAVE THE SAME PROBLEM IM HAVING? SO YOU THINK IF I CHANGE MY SPEEDOMETER GEAR IT WILL FIX MY TRANSMISSION PROBLEM THAT WOULD BE GREAT.
|
06-10-2001, 03:23 PM | #8 |
Registered Member
Join Date: Jan 2001
Location: Moline Il
Posts: 901
|
No I didnt have the same problem. At what speed is your speedo 6mph off? I doubt getting the right driven gear is going to fix your problem. Does it do the same thing at part throttle (almost floored) or is it only at wot?
|
06-10-2001, 03:39 PM | #9 |
Registered Member
Join Date: Jun 2001
Location: coweta OK USA
Posts: 93
|
I cound't tell the car is at the tranny shop and they are closed. do you have a aode with 3:73 GEARS
|
06-10-2001, 04:07 PM | #10 |
Registered Member
Join Date: Jan 2001
Location: Moline Il
Posts: 901
|
Yes I ran that combination for almost 2 years and never experienced what youre going through. I just recently swapped the AODE out in favor of a TKO. I've got a brand new AODE and stall convertor here if youre interested!!
|
06-10-2001, 04:14 PM | #11 |
Registered Member
Join Date: Jun 2001
Location: coweta OK USA
Posts: 93
|
what kind of aode , like where did you buy it from and what is your stall
|
06-10-2001, 04:19 PM | #12 |
Registered Member
Join Date: Jan 2001
Location: Moline Il
Posts: 901
|
check your mail.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
PennDot needs to send a memo out to mechanics & notaries | 82 GT | Blue Oval Lounge | 7 | 05-07-2004 02:29 PM |
Attention Pa. inspection mechanics or anyone that know one | 82 GT | Blue Oval Lounge | 2 | 04-01-2004 10:30 PM |
Pay of mechanics and auto body | vetteeatr | Blue Oval Lounge | 3 | 01-10-2002 10:09 PM |
Craftsman Mechanics Toolkit : Which to buy? | Gautam | Blue Oval Lounge | 31 | 10-01-2001 10:58 PM |
Attention pro mechanics. | slider | Windsor Power | 6 | 06-10-2001 12:36 AM |