Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-24-2002, 03:15 PM
|
#5 |
|
Registered Member
Join Date: Sep 2002
Location: pace.fl
Posts: 5
|
bearings
You need to resize all 8 rods. Rods become out of round with spun bearings and lots of use. Never install new rods bolts without resizing the rods. Make sure the rod chamfer always faces the outside when installed on crank. Standard clevite or FM bearings are fine for the rods. Your rings are broken from uncareful installation or ends butting.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Please help stutering problem | Just me | Windsor Power | 10 | 10-18-2002 02:37 PM |
| Diagnosis needed | bob megredy | Windsor Power | 1 | 06-15-2002 10:38 AM |
| engine idling problem | 87 GT MUSTANG | Windsor Power | 16 | 05-01-2002 03:10 PM |
| engine idling problem | 87 GT MUSTANG | Windsor Power | 6 | 03-23-2002 07:50 PM |
| engine idling problem | 87 GT MUSTANG | Blue Oval Lounge | 0 | 03-21-2002 02:10 PM |