© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-26-2001, 10:15 AM | #1 |
Registered Member
Join Date: Jun 2001
Location: Terre Haute, In. USA
Posts: 5
|
New MAM & injectors
just installed a C&L 76mm and 30# injectors.
why would the engine (cold) not respond to the thottle and why does it pop back into the intake....after it runs for a few minutes it will run fine...I had stock 70mm and 24# before and it ran fine......this is on a '90' coupe and it is supercharged |
06-26-2001, 10:29 AM | #2 |
Don Corlione
Join Date: Jun 2001
Location: Omaha NE USA
Posts: 491
|
I hope your new MAF is calibrated to your 30lb injectors. Check with the place you bought it from. If it isn't matched to your 30s, all you need to do is replace the sample tube in the MAF.
|
06-26-2001, 11:02 AM | #3 |
Registered Member
Join Date: Jun 2001
Location: Terre Haute, In. USA
Posts: 5
|
Yes it is suppose to be....the tube is colored purple per the instuctions
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Advice on injectors...PKRWUD I'd like your advice on this one as well | silver_pilate | Windsor Power | 3 | 06-09-2003 08:59 AM |
differences in injectors? | '89GTStang | Windsor Power | 9 | 06-06-2003 02:39 AM |
MAF and FPR independent from injectors? | Nixon1 | Windsor Power | 4 | 03-01-2003 02:00 AM |
Which Injectors Can I Use? | SPower6 | Windsor Power | 11 | 01-10-2002 04:46 PM |
will Chevy injectors work in a Ford | tireburner163 | Windsor Power | 4 | 06-16-2001 07:16 PM |