Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-19-2002, 02:47 PM
|
#6 |
|
Registered Member
Join Date: Dec 2001
Location: corinth miss
Posts: 19
|
NEW HARNESS!
you can build a new harness cheap! just use 1 heavy gage wire from the HOT side of your strarter solenoid over to the terminal on the back of the alt. thats the only 'stud with nut terminal'. make sure you find the right plug off a car that has the 130 amp alt also. Off that plug you will see a White wire with a small plug that plugs back into the alt. you will see a small Yellow Wire that you can just strip, put a terminal on it and install also on the stud/nut terminal. 1 other wire left "Green-With Red Stripe" just run it to 12v IGN. you will have that same Green-Red Stripe wire on your old harness. You can tie into it or just find another 12v IGN somewhere. I left my old harness and just ran that one heavier wire & tied into the Green-Red Stripe on the old harness.
__________________
Billy P. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| confused about how alternator brackets mount | 82 GT | Classic Mustangs | 1 | 09-30-2003 08:12 PM |
| g2 to g3 alternator swap | bosss50 | Windsor Power | 0 | 04-25-2003 05:14 PM |
| Weee! Alternator fire! | Scappoose | Windsor Power | 6 | 04-06-2002 03:01 AM |
| Alternator | xxrequiemxx | Windsor Power | 1 | 09-12-2001 02:16 AM |
| Underdrive pulleys | LincoConti87 | Windsor Power | 16 | 04-02-2001 10:42 PM |