

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
![]() |
#1 |
Registered Member
Join Date: May 2002
Location: New Jersey
Posts: 375
|
![]() i had the same problem with the summit h-pipe. THe hangers were on backwards so i had to grind them off and then the pipe was over 2 inches short. Also the first time they sent it, it didn't have o2 holes drilled in it so i had to send it back and get another one that didn't fit....
__________________
'89 LX 5.0, off-road h pipe, flowmaster muffs, underdrive pulleys, rebuilt WC T-5, King Cobra Clutch, 65mm throttle body, Explorer Upper/GT40 lower, Lakewood Rear Lift Bars. 76mm C&L Mass air w/ inlet pipe, Twisted wedge heads w/ stage 2 port,polish, MAC equal length shorties, Billet AFPR, 255LPH fuel pump, fresh low end w/ 10.5:1 compression. If anyone ever wants to go to Raceway Park in Englishtown New Jersey, give me a shout. RICER HATERS CLUB MEMBER 87! www.ricehatersclub.com |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cobra-R Side Exhaust -- SWEEET! | SkammyManX | Modular Madness | 3 | 04-05-2003 11:58 AM |
exhaust cross-overs?? | Simi Stang | Windsor Power | 7 | 12-09-2002 01:20 PM |
Speed Secret # 4 | jim_howard_pdx | Windsor Power | 13 | 11-10-2002 03:42 PM |
Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
Header gaskets | Stang951 | Windsor Power | 18 | 11-01-2002 05:57 PM |