© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-12-2002, 10:17 PM | #1 |
Registered Member
Join Date: Apr 2002
Location: Florida
Posts: 532
|
Heads and cam
I'm ready for heads, I was looking at the gt40 p's I believe there 270 a peice and cast iron and I was gonna install some 1.60 roller rockers before the install is this a good choice, my cars a daily driver and i'm lookin for some low 13 sec runs but also not break my bank can anyone give me some help I would also like maybe a E or B cam cause i'll also be changing my timing chain cause my cars goin on 140k plus miles.
__________________
90gt 347 and some bolt ons :-) RICE HATERS MEMBER #73 |
12-12-2002, 11:07 PM | #2 |
Registered Member
Join Date: May 2002
Location: South Carolina
Posts: 58
|
I like my GT-40p's
I am almost ready to put mine in the car. I would suggest getting the bare heads and putting good springs and valves with them. I replaced the springs on mine with Crane Cams Conical ones. The GT-40p heads from Frod Racing comes with standard production springs and locks with rotators. They are limited in lift to about 0.500".
My GT-40P equipped engine
__________________
Bobasaurus 1987 LX 5.0 - Engine Rebuild now installed - 26290 Wonderful Miles so far Items now installed from the garage : GT-40p heads, Explorer Intake, FMS "P" headers, Crower 15511, SFI Balancer, 24#, SPEC Stage 1, T5z, 65MM TB, 77MM Pro-M, 255lph Pump |
12-13-2002, 12:02 PM | #3 |
Registered Member
Join Date: Apr 2002
Location: Florida
Posts: 532
|
I was just looking for the most affordable head and roller rocker combo I could get cause my money is tight.
__________________
90gt 347 and some bolt ons :-) RICE HATERS MEMBER #73 |
|
|