Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-18-2002, 11:43 AM
|
#1 |
|
Registered Member
Join Date: Apr 1999
Location: seffner, Florida, usa
Posts: 95
|
alternator pulley to crank pully ratio
I have an 88 GT with a 347 and t trim. I needed a higher amp alternator for all the accessories and power so I picked up a 130 amp unit of a 95 v6. It still only barely makes it to the halfway on the gauge and is just above the red line at idle. Someone told me that the pully on the 130 unit may not be the right proportion to the vortech pully on the crank and it would only make a fraction of the juice I need. If so does anyone know what the ratio of the stock 95 v6 crank is to the 130 unit it came from?
I also have a high speed miss at about 5800. Car make 550 at the crank. Any suggestions?
__________________
88 GT mass air conversion from 90lx, Cobra Intake(ported/polished lower),Edlebrock Aluminum Heads(ported/polished),38# injectors 70 mm BBK TB, 77mm Pro M, Coast High 347 SB, Wolverine custom cam, Vortech T Trim w power pipe(13lbs), fmu & boost retard, 255lb fuel pump (BBK off road H pipe, Dynomax cat back, alum driveshaft w safety loop, Konis,Southside Bars w chromemoly torque boxes,AOD w lentech valve body, B&M MegaShifter, 4.10 with True Track locker, SVO springs, subs, cross drilled rotors, Nitto Drag Radials,MSD A6, black magic fan etc. |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| something behind the pully. | fordkid68 | Classic Mustangs | 23 | 04-30-2003 08:48 AM |
| crank shaft spacers | BilLster | Windsor Power | 0 | 04-24-2003 02:53 PM |
| Speed secret # 5 | jim_howard_pdx | Windsor Power | 37 | 11-15-2002 12:19 PM |
| 650HP stock block | ultraflo | Windsor Power | 73 | 11-07-2002 11:35 AM |
| Whats the best way to tell if your running lean or rich? | K.C. 5.0 | Windsor Power | 9 | 09-10-2001 03:04 PM |