Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-23-2003, 09:26 PM
|
#1 |
|
Registered Member
Join Date: May 2002
Location: Tampa,FLORIDA
Posts: 340
|
Spring question
my stock rear springs have a tube shaped piece of rubber inside them. It lines the inside of the spring. Not the isolators on top and bottom. My question is what are these for and do i need to put them back on my new ford racing springs?
__________________
5.0, Holley heads, 1.7 Scorp Rockers, Stealth intake, Holley 600 carb, Holley Mech. Fuel pump, MSD 6Digital, MSD distributor, Hotchkis upper/lower rear control arms, FMS B Springs, 3:73 (8.8) rear. Production # 9,377 |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Clutch Release lever Spring Question | orlowted | Classic Mustangs | 2 | 12-22-2003 06:32 PM |
| Valve Spring Question | 86GT | Windsor Power | 5 | 02-03-2003 08:13 PM |
| Front spring removal question... | BLACK85GT | Windsor Power | 6 | 01-17-2003 10:43 AM |
| Rear spring air bag question?? | Coupe Devil | Windsor Power | 4 | 10-06-2002 03:27 PM |
| Coil Spring Question?? | RMARIANI | Windsor Power | 1 | 01-29-2002 10:02 AM |