Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-21-2003, 09:53 PM
|
#2 |
|
Registered Member
Join Date: Feb 2002
Location: boulder city, nv
Posts: 6
|
i have a stock 87 upper ho and a stock 87 upper which was extrude honed. the cast dates are within 3 months of each other and the part #s are identical. there are minor exterior differences, (other than no ho on neck) but i have been told that before it was ported the non ho unit had a smaller diameter front port. i dont know what junk yard vehicle it was taken from, but it is clean.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Trouble! Cant remove upper intake plenum | 5.0 Fiend | Windsor Power | 8 | 09-09-2004 08:30 PM |
| anyone tried the b.a.r ported upper plenum ? | slow98 | Modular Madness | 9 | 07-28-2003 04:45 PM |
| porting upper plenum on 4.6..A MUST | sleeper_stang_2000 | Modular Madness | 14 | 07-16-2003 10:54 AM |
| What part is this???? '96 Mustang Cobra Upper Plenum | 96_4.6 | Modular Madness | 16 | 12-11-2002 12:02 PM |
| Engine oil in my intake upper plenum -please help | Stang_ROTY | Windsor Power | 8 | 08-03-2001 03:16 PM |