Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-24-2003, 07:08 PM
|
#5 |
|
Mustang Enthusiast
Join Date: Mar 2002
Posts: 528
|
you are in luck
I just had to buy some nuts because I bought a used h-pipe with no hardware and the hardware I had was rusted to hell. I have shorty headers, but they were 7/16" The head on the nut was a 11/16", (not like that matters much). Good luck, my advice, have two people under the car to hold & tighten the h-pipe bolts to the headers.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| crankshaft pulley bolt size | stanger8172 | Windsor Power | 2 | 05-26-2002 01:34 AM |
| Anyone know the nut size for shory header collector studs? | WhiteLX | Windsor Power | 0 | 08-01-2001 04:45 PM |
| Header Bolt | Jeff7477 | Windsor Power | 3 | 07-14-2001 04:03 PM |
| Header bolt size | swtstang | Windsor Power | 1 | 05-22-2001 07:03 PM |
| Head bolt size? help? | MAstang5O | Windsor Power | 1 | 02-07-2001 08:36 PM |