Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
03-23-2003, 07:04 PM
|
#1 |
|
Registered Member
Join Date: Mar 2003
Location: Wichita, KS
Posts: 53
|
I checked for slop in the tailshaft and there was none. I also tried reclocking the driveshaft in each of the other three locations and could not tell any difference. There are eight different ways to faze the axle with the differential. I guess I'll have to check the other four after I spray the holes with some penetrating oil and they can soak. I did notice that one of my muffler hangers has broken and my exhaust is slightly touching the UCA on one side and the frame on the other. I am going to try and get a new rubber hanger and some urethane from work and place it between these points.
__________________
Most recent project: installed new HD T-5 w/Pro 5.0 Shifter, LUK Clutch, Prothane Engine and Trans mounts. Currently breaking in clutch. Next: complete tune-up |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| vibration problem | KHC | Windsor Power | 5 | 09-10-2004 05:12 AM |
| Help! vibration problem!! | skiwesser | Windsor Power | 14 | 06-28-2004 01:41 AM |
| follow up to horrible vibration problem | Toeclicker | Windsor Power | 4 | 12-18-2003 06:38 PM |
| Vibration Problem | Phantom5oh | Windsor Power | 12 | 02-06-2003 10:18 AM |
| Think i found problem, vibration, and knocking noise?? | 90dpscoupe | Windsor Power | 2 | 10-14-2001 12:46 AM |