MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Register FAQ Members List Calendar

Notices


Reply
 
Thread Tools Rate Thread Display Modes
Old 04-02-2003, 05:35 PM   #1
chuck88
Registered Member
 
chuck88's Avatar
 
Join Date: May 1999
Location: Wood Ridge NJ USA
Posts: 341
Default Backfiring

I have an 88GT (speed density) GT 40 upper lower (Lower is ported) I have been told that I may have to much intake for stock heads.

My question The car backfires between 2000 & 2500 rpm when you push the pedal down semi hard (ok at wide open throttle)

what could cause this?

I am thinking of going heads, cam, & mass air conversion in the near furture would this cure the backfiring?

Thanks in advance

Chuck88
__________________
So what if its "midlife crisis".

Wife, 2 kids, busy job, "fixer upper" house, and I still have time for the Mustang!!!

I Love my kids!!!
chuck88 is offline   Reply With Quote
Old 04-02-2003, 07:53 PM   #2
Hethj7
Mizzou Tigers
 
Hethj7's Avatar
 
Join Date: Apr 1999
Location: weston, MO United States
Posts: 1,455
Default

My car had a backfiring problem for while. I found out I had a bad fuel injector. It wasn't flowing what it should and was essentially leaning out that cyclinder.
I replaced all 8 of them and haven't had a problem since.

When I had this problem a Ford dealer pulled the codes for me and did a flow test on the injectors. They just charged me for an hour of labor, which I didn't think was too bad at dealership.
__________________
2006 Mustang GT

1990 LX
GT-40 motor 262 horsepower, 307ft-lbs (sold but forever loved)

1998 Contour SVT

Rice Haters Club Member #244
Hethj7 is offline   Reply With Quote
Old 04-03-2003, 08:11 AM   #3
cyberstang5.0
347ci of HORSE POWER!!!
 
cyberstang5.0's Avatar
 
Join Date: Jul 2001
Location: Houston, TX
Posts: 1,416
Default

Also, double check your timing. That can cause you to backfire.
cyberstang5.0 is offline   Reply With Quote
Old 04-03-2003, 09:16 AM   #4
james87gt
Registered Member
 
Join Date: Jan 2002
Posts: 62
Default

check for vacuum leaks, timing, fuel pressure and also read your spark plugs
james87gt is offline   Reply With Quote
Old 04-03-2003, 06:54 PM   #5
SilverSN95
Registered Member
 
SilverSN95's Avatar
 
Join Date: May 2002
Location: Ontario
Posts: 39
Default

From what I understand a backfire is when you get combustion happening in the intake instead of the combustion chamber as intended. I thought there was only a few reasons for this to happen. First would be the timing of the valve positions and/or spark not matching the fuel injector firing. The other would be an extreme rich condition in the manifold such as when an injector is stuck open. Add a little spark and boom!!

Maybe a complete tune-up would help?
SilverSN95 is offline   Reply With Quote
Old 04-03-2003, 07:26 PM   #6
Hethj7
Mizzou Tigers
 
Hethj7's Avatar
 
Join Date: Apr 1999
Location: weston, MO United States
Posts: 1,455
Default

SilverSN95- That is a good point. My problem was a popping sound, probably not as loud as you would think a backfire would be, but still very audible. Sorry if this confused anyone.
__________________
2006 Mustang GT

1990 LX
GT-40 motor 262 horsepower, 307ft-lbs (sold but forever loved)

1998 Contour SVT

Rice Haters Club Member #244
Hethj7 is offline   Reply With Quote
Old 04-03-2003, 08:46 PM   #7
drtbiker
Registered Member
 
drtbiker's Avatar
 
Join Date: Jan 2002
Location: Mt. Prospect,IL
Posts: 474
Default

sounds like timing to me, my car did the same thing and i advanced the timing a little more and it was fine
later
raini
__________________
87-ford-mustang-SOLD!
mods: 3:73's, off road h-pipe, b303 cam in gt- 40 motor w/ Power Plus intake, edelbrock 70mm tb & egr spacer, 72mm C&L, bbk long tubes, tremec tranny, centerforce dual friction clutch, upr and lwr CA's 255lph FP and soon more to come.... when i have money again

SOME ADVICE
Don't do burn outs in reverse it is very expensive
New times with dead hook on dr's 13.27@103 with 2.0 60 foots w/100lb system

Fastest time to date: 12.8@113
drtbiker is offline   Reply With Quote
Old 04-05-2003, 12:05 PM   #8
94snake
Registered Member
 
Join Date: Nov 2002
Location: Panama City Fl.
Posts: 152
Default Backfiring

You should check your spark plugs. My 94 cobra had a similier problem, it would backfire betweem 2500 and 3500 rpm's. it was a bad spark plug that was grounding out on the header!
94snake is offline   Reply With Quote
Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Help! Backfiring and loss of power spuckie Blue Oval Lounge 1 11-24-2003 01:08 AM
Help! Backfiring and loss of power spuckie Windsor Power 1 11-21-2003 07:40 PM
Backfiring Problems! MITCHL Windsor Power 5 11-21-2002 01:52 PM
Backfiring on deceleration fixed !!!! 70 Pony Classic Mustangs 2 09-01-2000 08:37 AM
Backfiring on Deceleration... Idhomustang Classic Mustangs 12 08-31-2000 01:59 AM


All times are GMT -5. The time now is 08:21 AM.


SEARCH