![SEARCH](http://www.mustangworks.com/images/search.png)
![The Mustang Works](http://www.mustangworks.com/images/mw_footer_logo.gif)
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: Feb 2001
Location: Berkshire County - Massachusetts
Posts: 735
|
![]() Well I went with the MAC's due to the price (300.00) and I've "heard" that they are pretty good. Any comments on whether or not I made the right decision?
My choices were BBK's that probably won't fit w/out mods on a C4 - 430.00 Kooks that will fit - 800.00 Hookers that will fit also - 600.00 Should I reduce the collectors to 2 1/2 so I can retain my exhaust? Any expectations as to what performance gains I could get from this?
__________________
Red 1993 GT Street Machine Best E.T. - 12.41/Best MPH = 108 Engine is a 1969 351 block w/393 stroker kit. Dynamic Roller Myte C4, 8 pt cage. Edlebrock Performer heads and Victor Jr. EFI, FRPP 30lb injectors & Cartech fuel system. MSD ignition. Sothside Machine bars & Sub-frames, adj. upper's, 3.73's, Koni rear shocks, much more |
![]() |
![]() |
![]() |
#2 |
Registered Member
Join Date: Jun 2003
Location: Bay Area, Ca
Posts: 86
|
![]() so I take it you have the 3" collector, I believe you can get the 3" collector prochamber to match the headers and still have a 2 1/2" cat back system. Only problems I hear from MAC is their coatings don't last too long if it is the HTS, and when removing the headers, from the car to re-use again. make sure they are cold.
__________________
StAnGaHoLiC!!! 1995 GT S-Trimmed 306, with H/C/I, and some other stuff. It just sounds fast. My Car |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
MAC longtubes 96-98 4v smoke screen | jax702 | Modular Madness | 0 | 05-20-2003 12:34 AM |
Quick question on Longtubes... | 89LXRagtop | Windsor Power | 13 | 02-27-2003 11:31 PM |
Shopping for longtubes..any suggestions? | HiFlow5 0 | Windsor Power | 15 | 06-17-2002 06:06 PM |
Xpipe vs Hpipe with longtubes? | FivepointOH | Windsor Power | 4 | 10-07-2001 09:22 PM |