MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Register FAQ Members List Calendar

Notices


Reply
 
Thread Tools Rate Thread Display Modes
Old 07-15-2003, 12:03 PM   #1
Bad89stang
Registered Member
 
Bad89stang's Avatar
 
Join Date: Aug 2001
Location: Ft. Worth, TX
Posts: 456
Question A/C and blower motor question

Does being low on freon cause the A/C to pull more amperage/volts from the alternator?

My A/C works a little, but not that great. Whenever I turn on the A/C it draws big time from the electrical system. The higher the fan speed the lower the volts go. The car has been upgraded to a 130 amp alternator and it can't even keep up with the A/C.

Is this a blower motor problem or A/C related? I am leaning towards the blower motor since it does it when you turn the temp knob up. How can I test the blower motor? I have a digital voltmeter if that helps.
Bad89stang is offline   Reply With Quote
Old 07-15-2003, 02:19 PM   #2
QuantumMotorsports
Registered Member
 
Join Date: Jul 2000
Location: Norman, Oklahoma, USA
Posts: 597
Default

your blower motor is probably going out. Just a bearing inside it or maybe the brushes. You might want to get a new one or find a nice used one from a junk yard. The A/C compressor shouldn't make a difference so it should cause the voltage drop even when just running heat.
__________________
Michael Black
QuantumMotorsports
Norman, OK

1984 LX Hatch
306 w/ TRW forged flat toppers, Comp Cams Magnum 292H, GT40P heads w/ 3 angle valve job, .550 lift springs, Angus Racing Roller Rockers, Weiand Stealth Intake, Holley 4150 650cfm carb, MAC 1 5/8 Long Tubes, Single Chamber Flowmasters, 91' T5 w/ Pro 5.0 shifter, Turbo Coupe 8.8 Rear w/ 3.55 gears, QA1 Motorsports tubular K member, no interior except steering wheel and seat.
Coming soon: 6 or 8 point cage, Fuel Cell, Weld Draglites
QuantumMotorsports is offline   Reply With Quote
Old 07-15-2003, 03:15 PM   #3
Bad89stang
Registered Member
 
Bad89stang's Avatar
 
Join Date: Aug 2001
Location: Ft. Worth, TX
Posts: 456
Default

****. Thanks for the help.
Bad89stang is offline   Reply With Quote
Old 07-17-2003, 01:59 PM   #4
GhettoPop
Gimme a Drink!
 
GhettoPop's Avatar
 
Join Date: Dec 2002
Location: NYC
Posts: 694
Default

in my 90Gt i also noticed that the when using heat or A/C, my electrical system gets weak. car shifts and driveslike sh*t with the a/c on. i know the a/c hurts performance but i have not seen an a/c drain a car's power like it mine does.

i also noticed fan speed one does nothing basically, #2 and #3 are almost identical, and #4 is much much stronger. is my blower motor going? where can i pick up a new unit?
GhettoPop is offline   Reply With Quote
Old 07-17-2003, 02:15 PM   #5
Bad89stang
Registered Member
 
Bad89stang's Avatar
 
Join Date: Aug 2001
Location: Ft. Worth, TX
Posts: 456
Default

doesn't sound like you have the same problem as I do. Does it do it while on "vent" only? Take the A/C out of the equation and see if having just the blower motor on is causing any problems.

Mine doesn't affect the driving at all. Just pulls too many volts from the system.
Bad89stang is offline   Reply With Quote
Old 07-17-2003, 02:38 PM   #6
GhettoPop
Gimme a Drink!
 
GhettoPop's Avatar
 
Join Date: Dec 2002
Location: NYC
Posts: 694
Default

Quote:
Originally posted by Bad89stang
doesn't sound like you have the same problem as I do. Does it do it while on "vent" only? Take the A/C out of the equation and see if having just the blower motor on is causing any problems.

Mine doesn't affect the driving at all. Just pulls too many volts from the system.
The fan will work fine on vent or floor, but when i put it on "MIX" or especially on just the windshield, my electrical system takes a SERIOUS drain. sometimes with the heat on the windshield, when i push the clutch at a redlight, the car will drop RPM's and stall out. Help?
GhettoPop is offline   Reply With Quote
Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Questions about Alky/Water injection with a positive displacement blower stangsrule Power Adders 0 07-22-2003 12:58 PM
Another blower question bigred90gt Windsor Power 2 01-12-2003 11:14 AM
Novi blower problem exgmguy Windsor Power 3 05-18-2002 11:30 PM
Blower or n/a parts first: your thoughts? Capri306 Windsor Power 5 06-05-2001 09:17 PM
Why 3:55 gears for blower cars? Mike_W Windsor Power 2 05-26-2001 09:44 AM


All times are GMT -5. The time now is 10:03 PM.


SEARCH