Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-18-2001, 05:58 PM
|
#5 |
|
Undescribable
Join Date: Sep 1998
Location: Ft Myers Fla
Posts: 1,539
|
i just did this last weekend, i set the housing upside down and set the themostat there then just a bit of silcone then the gasket then more silicone and let it set for about 5- 10 minutes then i could set it in there and not have it fall out. i used a 180 degree robertshaw and my stang runs just below that on a 95 degree day here.
------------------ 93-LX: 5 Speed, Flow's with H-Pipe, 3.73's, C&L 76MM Kit, Sub's and K&N. 14.85 @95.83 [This message has been edited by lx mike (edited 08-18-2001).] |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 98 intake and thermostat | AutoX281 | Modular Madness | 3 | 09-26-2003 07:51 PM |
| changing a rear end | ragtop5point0 | Windsor Power | 7 | 02-06-2003 01:37 PM |
| Thermostat & Cooling System | GhettoPop | Windsor Power | 4 | 01-20-2003 07:54 PM |
| Thermostat 160* or 180*?? | NewStang02 | Small Ponies | 3 | 07-02-2002 10:26 AM |
| Changing ring & pinion gear is illegal | Ripper | Modular Madness | 1 | 04-06-2000 12:45 PM |