![SEARCH](http://www.mustangworks.com/images/search.png)
![The Mustang Works](http://www.mustangworks.com/images/mw_footer_logo.gif)
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: Jul 2001
Location: Refugio
Posts: 67
|
![]() If i push the white button on the bottom of the steering colomn and take they key out i have a VERY VERY VERY hard time to make the key turn to the on possition. i mean i can put the key in ( and it also requires force to get it out ) and the try to turn it and nothin.. it doesn't move.. it took me an hour and then 1 1/2 hours to get it to work the other two times it did this.. i have just not been taking they key out, i just left it in there so this doesn't happen... now i can't turn my car on?!
|
![]() |
![]() |
![]() |
#2 |
Registered Member
Join Date: Jan 1999
Location: Maryland
Posts: 74
|
![]() I would spray it good with WD-40 or something like that and try it for a while...If it doesn't help then the tumblers are worn bad and the key switch should be replaced. Remember that the key has to be turned to the run position to be removed(by pushing the locking pin in underneath the key switch) Good luck MeanGene
|
![]() |
![]() |
![]() |
#3 |
Registered Member
Join Date: Jul 2001
Location: Refugio
Posts: 67
|
![]() how would i go about replacing the key switch?
|
![]() |
![]() |
![]() |
#4 |
Registered Member
Join Date: Jan 1999
Location: Maryland
Posts: 74
|
![]() Remove the plastic cover from the steering column. I think you will be able to see the switch from there. If not you might have to remove the steering wheel. When you get to it, turn the key to the run position and push in the little pin on the bottom side of the switch and pull out on the key. It should come right out. Good luck MeanGene
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
ignition switch gremlins ( long post? bear with me) | Marc91gt | Windsor Power | 1 | 09-04-2003 09:05 PM |
turn signal-maybe the whole harness-calling all electricians? | rwhite65 | Classic Mustangs | 6 | 07-25-2003 08:40 AM |
Ignition would not turn off! | PonyCrazyGal | Classic Mustangs | 6 | 06-15-2002 05:32 PM |
ignition timing problems | MetalHead | Classic Mustangs | 7 | 03-21-2002 07:28 PM |
Ignition frabrication...needs some ideas | 1989_351W | Windsor Power | 0 | 08-11-2001 04:52 PM |