![SEARCH](http://www.mustangworks.com/images/search.png)
![The Mustang Works](http://www.mustangworks.com/images/mw_footer_logo.gif)
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: Mar 1999
Posts: 88
|
![]() Ok, all i did was swap a 70MM to 65, set TPS to .986. Start her up, and check engine light is on, so i do a KOEO and KOER
KOEO: 85-can purge, none there 56- MAss air above max voltage KOER: 98- Hard fault FMEM Mode...? can anyone shed some light on this..? Again all i did was swap TB's thanx very much in advance@!@!! .dave .dave |
![]() |
![]() |
![]() |
#2 |
Registered Member
Join Date: Oct 1998
Location: Rogers, MN
Posts: 2,089
|
![]() FMEM is Failure Mode Effects Management.
This means that since there is something wrong with your mass air meter the computer is going to just use look up tables based on other information. It's basically a limp home mode. Try resetting your computer. If it is still a problem afterwards, I would suspect that your MAF sensor was the cause of the problem for which you changed the throttle body. ------------------ 351W 89 Mustang GT Convertible |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Code 81?? Code 51. HELP!! | blk88lx | Windsor Power | 0 | 03-31-2004 08:22 PM |