Shifter swap, console removal??

fiveohpatrol · 08-27-2001, 06:13 PM

get a small screwdriver and pop up each corner of the black panel one at a time,(easier and safer than pulling the whole thing up) once that is up you will have to unsrcrew the shifter knob and the boot/panel can come off, then theres a rubber insulation piece with a metal holddown you have to unscrew and take out, then you can get to the shifter, take the 4 bolts out, it most likely will be stuck on there really good, you'll have to pry it up because there's sealant on the underside of the shifter,
about the back 2 bolts, you may want to get a pair of sidecuts and "modify" your console in the area that you wont see when you put it back together, make 2 cutouts in the plastic so you can get a ratchet extension in there, you could also follow the directions that come with the shifter

------------------
88 Notch, B&M Ripper, 3.73's, Ported E7's, Explorer int. w/ ported lower, pulleys, 1.7RR's, BBK headers, off-road H-pipe, flowmasters, subframes, 65mm TB, March ram air ,MSD coil, U/L control arms, 155lph f/p, Crane Adj.FPR, Nitto drag radials, best 1/4--> 13.76@101.4 on a 2.17 60ft

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
No Need for Aftermarket Shifter after this Mod !!	Katmandu	Windsor Power	6	03-24-2004 06:07 PM
console swap	sallen85	Windsor Power	7	04-20-2003 08:02 AM
what would you ask for for christmas??	lx5091	Windsor Power	28	11-22-2002 10:52 AM
Mac shifter install questions	Chevyguy	Windsor Power	5	10-22-2001 03:01 PM
aod shifter handle swap?	sockmonkey	Windsor Power	2	08-06-2001 01:05 PM

08-27-2001, 06:13 PM	#5
fiveohpatrol I'd rather be basketweaving Join Date: Feb 2000 Location: Indianapolis Posts: 2,551	get a small screwdriver and pop up each corner of the black panel one at a time,(easier and safer than pulling the whole thing up) once that is up you will have to unsrcrew the shifter knob and the boot/panel can come off, then theres a rubber insulation piece with a metal holddown you have to unscrew and take out, then you can get to the shifter, take the 4 bolts out, it most likely will be stuck on there really good, you'll have to pry it up because there's sealant on the underside of the shifter, about the back 2 bolts, you may want to get a pair of sidecuts and "modify" your console in the area that you wont see when you put it back together, make 2 cutouts in the plastic so you can get a ratchet extension in there, you could also follow the directions that come with the shifter ------------------ 88 Notch, B&M Ripper, 3.73's, Ported E7's, Explorer int. w/ ported lower, pulleys, 1.7RR's, BBK headers, off-road H-pipe, flowmasters, subframes, 65mm TB, March ram air ,MSD coil, U/L control arms, 155lph f/p, Crane Adj.FPR, Nitto drag radials, best 1/4--> 13.76@101.4 on a 2.17 60ft