Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
03-31-2004, 12:16 AM
|
#1 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
If you heat the flange up enough the bolts will come right out like a hot knife through butter
 Be careful not to strip the bolts with the impact gun, it is hard to get in there enough to fully engage them.
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Where can I find some header bolts? | 96_4.6 | Modular Madness | 5 | 11-08-2003 10:22 PM |
| Only 3 bolts holding fan to water pump? | Hethj7 | Windsor Power | 5 | 03-27-2003 03:26 PM |
| Pressure plate bolts | WhiteLX | Windsor Power | 1 | 09-15-2002 06:50 AM |
| Console Armrest Bolts | Southpaw | Windsor Power | 3 | 12-26-2001 09:56 AM |
| WTF? Ring gear bolts came loose and went threw Diff cover! | 93CobraR | Windsor Power | 6 | 11-07-2001 07:23 PM |