![SEARCH](http://www.mustangworks.com/images/search.png)
![The Mustang Works](http://www.mustangworks.com/images/mw_footer_logo.gif)
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: Apr 1999
Location: Nebraska
Posts: 12
|
![]() I am looking for O2 extentions for my BBK LT's. In another thread, someone mentioned Interactive Tech. I've tried a search but have come up empty. BBK or Summit don't mention this part in their catalogs. Thanks.
------------------ 92conv, T5, HPMsubs, 4pt gload, strut tower brace, 3.55's, 3 chamber Flowmasters, Baer SS brake lines |
![]() |
![]() |
![]() |
#2 |
Registered Member
Join Date: Aug 2000
Location: santa ana ca
Posts: 1,349
|
![]() I am going to have the same problem, You probably read about it in my other thread. I have a good technician helping me with this and he is going to extend my harness instead of the sensor because O2 sensors fail and elongating them can be a pain, plus you can ruin them if your not careful. Its also a federal crime to modify your O2 sensors but its not if you elongate the harness instead. I should be getting my headers today. If I get mine installed before you I will tell you exactly how he did it. good luck.
------------------ 95GT B303 cam, 1.7 rockers, 65mm TB, 73mm MAF, milled heads, 355's K&N, off road pipes, pulleys, msd coil, 9mm wires, Tremec 3550, Pro5.0 shifter,10.5 Motorsport clutch, weld in subframe connectors |
![]() |
![]() |
![]() |
#3 |
Procharged!
Join Date: May 1999
Location: Hanover, PA
Posts: 1,539
|
![]() I am the one who mentioned the Interactive Technologies
![]() ![]() The Web Address is- www.mass-air.com they are $34.95 for a set and their # is 800.820.1082, tech line 770.720.1259. ------------------ My Ride Check Out My Site 91GT, Holley SysteMAX II Kit-Heads 2.02" x 1.60",Full MAC exhaust 1-5/8" Long tubes, 2-1/2" O.R H-Pipe, 2 1/2" cat back, 12" K&N Filter, RNH PERFORMANCE Ram Air, Ron Davis Radiator, Full Suspension,3:73's, Welds, Best on new motor-12.60 @ 108, no traction 1.98 |
![]() |
![]() |
![]() |
#4 |
YOU HAVE NO MARBLES!!!!!!
Join Date: Aug 2000
Location: Jonesboro,Georgia,USA (Providence, Ri)
Posts: 868
|
![]() I just tried to go to their web sight and it was not up yet. It just said "comming soon". That area code is the same as mine, do you know where they are located? Light Em Up!!!
![]() |
![]() |
![]() |
![]() |
#5 | |
Procharged!
Join Date: May 1999
Location: Hanover, PA
Posts: 1,539
|
![]() Quote:
1105 Hasty Trail, Canton, GA 30115 ![]() ------------------ My Ride Check Out My Site 91GT, Holley SysteMAX II Kit-Heads 2.02" x 1.60",Full MAC exhaust 1-5/8" Long tubes, 2-1/2" O.R H-Pipe, 2 1/2" cat back, 12" K&N Filter, RNH PERFORMANCE Ram Air, Ron Davis Radiator, Full Suspension,3:73's, Welds, Best on new motor-12.60 @ 108, no traction 1.98 |
|
![]() |
![]() |
![]() |
#6 |
Registered Member
Join Date: Sep 2000
Location: New Hope MN USA
Posts: 276
|
![]() How long of extensions do you need, where is the oxygen sensor placement. The reaon I ask is I has somewhat of the same problem but with only one location, drivers side I think, but I just bought another O2 sensor with a longer length, they sell then in different wire lengths and it worked perfectly, how much extra do you need? I think the lenghts are 6", 8" and 10".
------------------ 91 LX Convertible Gray on Red B&M Shift improver kit,ASP red alum. underdrive pulleys, Richmond 3.73 gears, 1 5/8 Flowtech long tube Headers and off road h-pipe, Flowmaster 2-chamber cat-back with S.S exhaust, MSD 6A Ignition with coil,Cap and rotor, Taylor Pro wires, K&N 12" conical filter system, Jet stage 2 performance chip and just purchased some GT40P heads, looking at exhaust, Lentech Street Terminator plus on it's way... |
![]() |
![]() |
![]() |
#7 |
YOU HAVE NO MARBLES!!!!!!
Join Date: Aug 2000
Location: Jonesboro,Georgia,USA (Providence, Ri)
Posts: 868
|
![]() I just ordered mine for about $40 includes tax and S&H. They are in my area code. Light Em Up!!
![]() |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mustang Coupes Website!! | nicklfire | Blue Oval Lounge | 2 | 01-27-2004 12:13 AM |
Billy Glidden's new website | Eric4Nitrous | Blue Oval Lounge | 22 | 08-13-2002 09:45 PM |