MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Register FAQ Members List Calendar

Notices


 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old 05-05-2004, 08:51 AM   #2
crazypete
Registered Member
 
crazypete's Avatar
 
Join Date: Sep 2002
Location: Boston
Posts: 592
Default

Ok, speaking as someone who has basically replaced practically every wire in the entire car (cause it was all screwy and shorting out) and threw most of them out, I would have to say nay nay. The wiring to the 87-93 console uses a pair of plugs to supply signals through this plastic sheet with traces to operate the gauges on the console. It's conceiveable that you could snip and splice till everything worked and I doubt it would be nightmarishly bad, but it would be a project. I know some things like......the oil level sender??... use a module and you would need to obtain it and wire it up.

Honestly, I'd be interested in going from my 87-93 dash to the earlier 79-85 dash. I think the older analog looking gauges on the old dashes and the recaro seats are sexy.

My humble opinion is stick with what you got.
__________________
91 GT Carb conversion, holley 600 double pumper, edelbrock performer intake, FMS "C" drop springs, march 1000 underdrive pullies, crane 1.7 roller rockers, GT-40P headers, bassani x pipe, american thunder catback, FMS 4.56's, msd aL6, trunkmount battery, A/C eliminator kit, 3000 stall tci streetfighter, AOD with transgo kit, A+ servo, 300M hardened lockup shaft, kevlar bands and 28,000 gvw trans cooler, 3 core radiator, 300 lbs stripped with a full interior

Last edited by crazypete; 05-05-2004 at 09:07 AM..
crazypete is offline   Reply With Quote
 



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
5 lug conversion stanger9219 Windsor Power 2 02-25-2004 11:31 PM
What all do you need to do rear disc conversion w/ SN95 Parts KG88GT Windsor Power 1 07-29-2003 01:45 PM
questions about maf conversion spankaveli Windsor Power 10 10-19-2002 02:46 PM
5 to 4 lug conversion mike_navigator Blue Oval Lounge 7 08-14-2002 11:17 PM
mass air 87GT conversion greydan Windsor Power 3 01-02-2002 07:57 PM


All times are GMT -5. The time now is 08:14 PM.


SEARCH