![SEARCH](http://www.mustangworks.com/images/search.png)
![The Mustang Works](http://www.mustangworks.com/images/mw_footer_logo.gif)
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: Dec 2003
Location: Ohio
Posts: 5
|
![]() I have an 86 gt with a 93 h.o. motor that i bought and i was bored and checked the timing and it was at 20.5 degrees without the little black connector thing i put that back in and its almost 30 degrees at idle, is this normal. Im not sure what the motor has in it but it runs pretty wild. The only modifications i know of on the motor are a edelbrock 5.0 performer intake, bbk equal length headers, flowmasters, underdrive pulleys.
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
![]() Is the motor fuel injected or carbed? With fuel injection, you'll want to remove the spout connector (grey) that is right in front of the distributor...your timing should be at 10 degrees btdc with that removed. The same #s hold true for a carbed setup...but you'll be removing the vacuum advance hose (black) and then setting the timing. But you should put it on 13 or 14 for a little more performance. 20+ degrees is way too high.
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Total timing vs initial timing for max HP. | Dark_5.0 | Windsor Power | 35 | 04-28-2009 11:35 PM |
Check engine light after steeda pullies / timing adjuster!! HELP!! | MineralGray02K | Modular Madness | 1 | 09-29-2002 01:11 AM |
points and timing specs | xfernal | Classic Mustangs | 1 | 12-30-2001 04:20 PM |
timing chain or timing gear | mustang66teen | Classic Mustangs | 11 | 06-18-2001 08:44 PM |
nos & timing controller | todd5litre | Windsor Power | 5 | 01-09-2001 08:24 PM |