Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-13-2004, 06:17 PM
|
#1 |
|
Domestic Rice really sucks!
Join Date: Apr 2002
Location: KY
Posts: 973
|
Alternator/Belt tensioner?
Check the attached picture. Where can I get one of these turnbuckle apparatuses to use to tighten the belt? This looks so much cleaner than that ugly ass stock belt tensioner.
__________________
The sig says it all. 
|
|
|
|
07-13-2004, 06:48 PM
|
#2 |
|
I'm slow ...I know.
Join Date: Dec 2003
Location: houston
Posts: 518
|
try www.jegs.com or summitracing.com i think march performance makes something like that
|
|
|
|
|
07-15-2004, 02:07 AM
|
#3 |
|
Registered Member
Join Date: Jun 2004
Location: Hawaii
Posts: 8
|
Yeah Jegs has them. Only for cars w/o AC. Nnever knew that till I tried to install
__________________
92 Calypso LX 5 spd, 6# P-1SC2, 3.73's, GT-40 upper/lower, BBK 65MM TB, Pro-M ATI Blowthrough MAF, 30#'s, Edelbrock 6037's, F-cam, 1.6 rockers, BBK Ceramic shorties, BBK O/R H, 2-chambers, MSD 6al, blaster coil, 255 in-tank, upper/lower control arms, subframes, Weld fat and skinnies. 11.86 @ 117 on old dry Nitrous set-up (100 shot) spinning 1st and 2nd. Only 1 run, no bar, got da boot 
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Reversing the belt tensioner | Ieatcamaros | Windsor Power | 4 | 08-19-2003 06:04 PM |
| Powerdyne tensioner problem after smaller pullie | Chipdog | Windsor Power | 10 | 03-10-2002 11:39 AM |
| alternator, and belt tensioner? | 90dpscoupe | Windsor Power | 2 | 08-05-2001 02:50 AM |
| Serpentine Belt Tensioner | rtz | Windsor Power | 15 | 03-09-2001 02:28 AM |
| Tensioner pulley for 87 2.3 | Mark McDaniel | Small Ponies | 1 | 06-06-1999 12:54 PM |