

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: Nov 2000
Location: INDIO CA USA
Posts: 141
|
![]() I have a ATI Comp trans that is about 1500 miles old. It has all the goodies except the trans brake. The other day I got into my car and it wouldn't go into Reverse. So i pushed the car out and went from 1st,2nd, but when i went to 3rd it stayed in 2nd. I checked my shift linage and its woking fine. the fluid is not burt and is extremely clean. I don't see how I could drive it one day and the next it be shot.
Please help if you can. Thanks |
![]() |
![]() |
![]() |
#2 |
Registered Member
Join Date: Feb 2001
Location: Berkshire County - Massachusetts
Posts: 735
|
![]() I had that problem except my fluid was low. Even a 1/2 a qt. is enough to do it. Check your fluid and good luck.
------------------ Just need the sticker! Red 1993 GT 1969 351 block w/393 stroker. Edlebrock Performer heads and Performer RPM EFI, FRPP 30lb injectors & Cartech fuel system. JMS chip & MSD ignition. Dynamic Roller Myte C4, 8 pt cage, Sothside Machine bars & Sub-frames, adj. upper's, 3.73's, Koni rear shocks |
![]() |
![]() |
![]() |
#3 |
Registered Member
Join Date: Nov 2000
Location: INDIO CA USA
Posts: 141
|
![]() Thanks for the help. I checked the fluid again and it was full. I tried even adding a quart of fluid and still nothing. Before I added the quart it went in to reverse once. Then I added it and nothing. I even disconnected the shifting linkage and manually shifted it, but still nothing.
Anybody go any more ideas. Thanks |
![]() |
![]() |
![]() |
|
|