© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-09-2001, 12:05 PM | #1 |
Registered Member
Join Date: Apr 2001
Location: Bloomington, IL
Posts: 25
|
Head Rebuild ?
I'm going to mildly port my stocker heads while I have the lower end rebuilt. And I wanted to rebuld the heads myself. I was thinking of going with 1.7 roller rockers since I'm not going with a new cam. Those stud mounts are easy to install right?? And as far as valve springs, I'm lost... So any input with those would help. And should I replace those valves.. or just clean them up ... 3 angle valve job.. ?? I dunno what to do yet.
Thanx. Mike5p0 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Loud knock after head rebuild | Hozer 88GTConv | Windsor Power | 9 | 03-12-2004 11:21 PM |
T-5 Rebuild | 95/GT/5.0 | Windsor Power | 9 | 12-26-2002 10:23 PM |
what head ? | faststang90 | Windsor Power | 3 | 09-08-2002 07:17 PM |
Anyone ever used the ultra seal 5751 silicor head gaskets yet? | 11secondGT | Windsor Power | 0 | 08-06-2002 10:23 PM |
Head rebuild | Mike5p0 | Windsor Power | 2 | 01-23-2001 08:43 PM |