Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-22-2005, 10:55 PM
|
#4 |
|
Registered Member
Join Date: May 2003
Location: Montreal
Posts: 8
|
Re: Edelbroock RPM head on a 393
For the compression ratio, i get 11.33 with a 9.503 deck, 60cc chamber and a .041 tick gasket.
Should i mill down the deck and get dish pistons to maximise quench? What compression ratio should id stay to run on pump gaz ? Tanks. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Head Gasket | tarmon8r | Windsor Power | 1 | 04-15-2005 07:15 PM |
| GM Engines | BLOCKER | Blue Oval Lounge | 2 | 04-13-2004 12:35 AM |
| Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
| Experience with Edelbrock RPM Package | jim_howard_pdx | Windsor Power | 0 | 10-27-2002 01:10 AM |
| what head ? | faststang90 | Windsor Power | 3 | 09-08-2002 07:17 PM |