Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-08-2005, 04:22 PM
|
#1 |
|
Registered Member
Join Date: Sep 2001
Posts: 512
|
Manifold spacers ?
We're installing the Edlebrock Performer upper and lower on our 331, the vacuam connector on lower side of upper didn't clear the valve covers, we need to use due to the 1.6 rockers.
We just picked up an Edlebrock spacer which gives us the clearance. Any comments on using these pros and cons? We noticed there's two bolts in the center of the manifold which are not used with the spacer. |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 4.6 intake manifold help | Zim28 | Modular Madness | 3 | 04-08-2005 07:21 PM |
| My intake manifold broke :( | Blackstare | Modular Madness | 5 | 04-01-2005 06:50 AM |
| lines from carb to manifold? | rfisch | Classic Mustangs | 1 | 01-31-2005 10:15 PM |
| 351W crankcase evacuation | jse9 | Windsor Power | 19 | 09-03-2004 12:00 AM |
| crank shaft spacers | BilLster | Windsor Power | 0 | 04-24-2003 02:53 PM |