Threaded Mode
© Copyright 2026 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-16-2005, 06:55 PM
|
#18 |
|
Registered Member
Join Date: Mar 2002
Location: DC
Posts: 129
|
Re: Car won't start. Long.
Well,
I traced the wires from my Crane Ignition box. Can someone tell me where to find instructions on how to un-hook this box. I see how to un-hook the power and ground wires from the box, but there are 2 blue wires that run from the crane box directly to the coil. Were should I look to find the original wires that ran to the coil before the crane box was installed. Also there are 2 small white wires that run from the crane box to the factory harness, and then right into the firewall.
__________________
87 GT As of 2/1/06 650 DP Carb Crosswind Intake Edelbrock Performer Heads 97 Explorer Bottomend w/ B-303 Cam 1.7 Roller Rockers Flowtech Longtube Headers Flowtech H-Pipe MSD Black Wires MSD ignition MSD Distributor Blaster 3 Coil Electric Fan Underdrive Pullies T5 Trans Hurst Shifter Lowered 1.5" 373 Gears |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| EEC does not energize unless key turned to start | crazypete | Windsor Power | 23 | 09-20-2002 09:00 AM |
| AOD-T-5 no start & reverse lights no go? | STBEAR007 | Windsor Power | 3 | 08-02-2002 04:40 AM |
| TFS High Ports and Long Tubes | HORSEMEN RACING | Windsor Power | 3 | 07-16-2002 12:57 PM |
| help pleeze.... running like sh't, now won't start (long) | about-2-give-up | Windsor Power | 3 | 09-27-2001 09:14 AM |
| DSS 306 short block etc etc? (very long) | DemonGT | Windsor Power | 3 | 01-24-2001 11:09 PM |