![SEARCH](http://www.mustangworks.com/images/search.png)
![The Mustang Works](http://www.mustangworks.com/images/mw_footer_logo.gif)
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: Nov 2002
Location: Panama City Fl.
Posts: 152
|
![]() was curious.... anyone running an oil seperator? noticed a lil oil consumtion... i pull pcv out of lower intake and realize a bit of oil there. Ive heard of aftermarket intakes n there higher vaccumm could possibly cause this. A budddy tells me its a wet motor !! any ideas
|
![]() |
![]() |
![]() |
#2 |
Factoy Five Roadster
Join Date: May 2000
Location: Sevier Co,Tennessee
Posts: 1,681
|
![]() Under the PCV valve is a wire screen. If it cloggs, oil will get sucked into the inake through the PCV valve like a straw. Remove and clean, or buy a new one.
Not sure what a "wet" motor is. If your motor has alot of blow by, its going to suck/burn oil, no matter what you do.
__________________
Frank |
![]() |
![]() |
![]() |
#3 |
13.3 @ 103
Join Date: May 2001
Location: Maryland
Posts: 253
|
![]() I made my own:
http://groups.msn.com/1998redmustang...to&PhotoID=348 http://groups.msn.com/1998redmustang...to&PhotoID=344 Air /water separator $11.00+ two 1/4 NPT 90 degree 3/8" opening brass fittings $5.00. Or one 90 degree and one straight fitting depending on how your PCV is set up. Just splice in between PCV and intake...works great with the Eaton, I've seen this used with N/A applications also.
__________________
Equipment by: Steeda C&L COMP CAMS FRPP MSD Bassani Magnaflow MAC ![]() ![]() ![]() |
![]() |
![]() |
![]() |
#4 |
Registered Member
Join Date: Nov 2002
Location: Panama City Fl.
Posts: 152
|
![]() rite on thanx ppls im gonna try one and see how it does.... ive never heard of a wet motor either.... farely fresh motor i would say around 15,000 miles or so. i thought replacing factory heads with sum edelbrocks would save the old valvetrain n wut not but still consuming... they are 30 over Ross pistons and i believe file to fit rings any ideas motor is completely rebuilt.... EFI car
|
![]() |
![]() |
![]() |
#5 |
13.3 @ 103
Join Date: May 2001
Location: Maryland
Posts: 253
|
![]() I'm sure you would have figured but...when the bowl is half full, empty it. You shouldn't have to empty it much with N/A applications. Good luck...
__________________
Equipment by: Steeda C&L COMP CAMS FRPP MSD Bassani Magnaflow MAC ![]() ![]() ![]() |
![]() |
![]() |
![]() |
|
|