I'm taking my Mustang to the track (any guesses on how Fast) - Page 2

68Falcon · 03-06-2005, 08:01 PM

The only thing I did to the motor was blue print it. I was footbraking it. The first two runs I shifted at 5000. The last two run I shifted at 5200 and went threw at different RPM each time depend on how bad it spun. It varied from 5400-5700.

68Falcon · 03-07-2006, 09:56 PM

Well It's a year later and I haven't changed anything just did some tuning on the carb.. 1.66 60ft 7.99@84 1/8 and 12.62@106 1/4

68Falcon · 08-10-2006, 09:38 PM

Well in April I got a new best 1.65 60ft 7.97@85 1/8 12.61@105 1/4
Here is the 12.61@105 pass
http://media.putfile.com/4-14-1-45

In July I got my Best NOS pass which I've only made 6 of them. This is on a 175 shot. 1.54 60ft 7.16@95 1/8 11.33@116 1/4
Here is my 11.33@116 pass
http://media.putfile.com/7-28-06-pass-2

Dark_5.0 · 08-11-2006, 05:38 PM

You got the 351 running real good.

I am going to the track in about an hour. Hoping for low 12's @110mph

Dark_5.0 · 08-11-2006, 08:45 PM

Quote:

Originally Posted by Dark_5.0

You got the 351 running real good.

I am going to the track in about an hour. Hoping for low 12's @110mph

Guess what it rained!!!!!!!!

I'll try again tomorrow.

82 GT · 08-14-2006, 10:54 PM

Quote:

Originally Posted by 68Falcon

Well It's a year later and I haven't changed anything just did some tuning on the carb.. 1.66 60ft 7.99@84 1/8 and 12.62@106 1/4

You dropped 3 tenths with just carb. tuning? That's cool! What did you change in the carb?
Hearing this gives me hope of tweaking more E.T out of my setup.
I just ran a best of 12.93@102 and feel there's more in my setup.
I'm curious to the changes you did to knock off 3 tenths.

68Falcon · 08-14-2006, 10:59 PM

I put jet extensors on it and bigger accelerator pump on it and played with the air mixture screws.

82 GT · 08-14-2006, 11:19 PM

I'm assuming you went from 30cc pumps to 50cc..? We have very similiar setups I'd like to get 12.6's out of mine too.
What size PV are you running?

68Falcon · 08-15-2006, 04:48 AM

The Carb is stock beside what I did to it. I don't know what power valve is in it. The reason why I put the 50cc accelerator pump on it was for the Spray.

Rev · 08-15-2006, 05:29 PM

I had to put a 50 cc pump in my 625 Road Demon when I changed cam ( 218/218 to 224/230 @ .050) and to an Edelbrock Air Gap. I also had to open up the pvcr's some as well as open up the low speed air bleeds a little. Suprised me some to have to do all that to get rid of the lean bog and lean stumble at cruise speeds. Also had to play with the secondary vacuum springs some for best results.

I don't think there's any end to the carb tuning one has to do when changes are made in other areas. Mine does have to remain streetable.

Rev

82 GT · 08-15-2006, 09:52 PM

REV...what size converter do you have now and what are your 60' times? You just need a little more ummmmph to crack the 12's.
I'd like to see your beast break the 12's too!
When you do break the 12's, you'll be like me and wanting 11's then...LOL....but I'm going to "juice" my way into the 11's though..LOL

03-06-2005, 08:01 PM	#21
68Falcon Bracket Racer Join Date: Apr 2003 Location: Loxahatchee, Florida Posts: 210	Re: I'm taking my Mustang to the track (any guesses on how Fast) The only thing I did to the motor was blue print it. I was footbraking it. The first two runs I shifted at 5000. The last two run I shifted at 5200 and went threw at different RPM each time depend on how bad it spun. It varied from 5400-5700. __________________ Streetcar 90 Notch 69 351W .030 over. Untouched 69 351 heads Crane cams duration @050 216in 228ex. valve lift .484in .512ex. Untouched RPM air gap intake with Holley 750 DP. Hooker headers. C6 trans. 8.8 with 3.73, Strange 31spline alxes and spool Racecar 68 Falcon 10 point Cage and FE487ci 13.6:1 compression. .740 lift 276in 284ex duration @.050 in the Works. 428CJ heads. Port O Sonic intake with 1050 Dominator. PowerGlide trans.

03-07-2006, 09:56 PM	#22
68Falcon Bracket Racer Join Date: Apr 2003 Location: Loxahatchee, Florida Posts: 210	Re: I'm taking my Mustang to the track (any guesses on how Fast) Well It's a year later and I haven't changed anything just did some tuning on the carb.. 1.66 60ft 7.99@84 1/8 and 12.62@106 1/4 __________________ Streetcar 90 Notch 69 351W .030 over. Untouched 69 351 heads Crane cams duration @050 216in 228ex. valve lift .484in .512ex. Untouched RPM air gap intake with Holley 750 DP. Hooker headers. C6 trans. 8.8 with 3.73, Strange 31spline alxes and spool Racecar 68 Falcon 10 point Cage and FE487ci 13.6:1 compression. .740 lift 276in 284ex duration @.050 in the Works. 428CJ heads. Port O Sonic intake with 1050 Dominator. PowerGlide trans.

08-10-2006, 09:38 PM	#23
68Falcon Bracket Racer Join Date: Apr 2003 Location: Loxahatchee, Florida Posts: 210	Re: I'm taking my Mustang to the track (any guesses on how Fast) Well in April I got a new best 1.65 60ft 7.97@85 1/8 12.61@105 1/4 Here is the 12.61@105 pass http://media.putfile.com/4-14-1-45 In July I got my Best NOS pass which I've only made 6 of them. This is on a 175 shot. 1.54 60ft 7.16@95 1/8 11.33@116 1/4 Here is my 11.33@116 pass http://media.putfile.com/7-28-06-pass-2 __________________ Streetcar 90 Notch 69 351W .030 over. Untouched 69 351 heads Crane cams duration @050 216in 228ex. valve lift .484in .512ex. Untouched RPM air gap intake with Holley 750 DP. Hooker headers. C6 trans. 8.8 with 3.73, Strange 31spline alxes and spool Racecar 68 Falcon 10 point Cage and FE487ci 13.6:1 compression. .740 lift 276in 284ex duration @.050 in the Works. 428CJ heads. Port O Sonic intake with 1050 Dominator. PowerGlide trans.

08-11-2006, 05:38 PM	#24
Dark_5.0 Registered Member Join Date: Apr 2001 Location: Staging lane Posts: 4,337	Re: I'm taking my Mustang to the track (any guesses on how Fast) You got the 351 running real good. I am going to the track in about an hour. Hoping for low 12's @110mph __________________ 92' LX-Big brakes, Lots and lots of suspension, GT40X heads, Ported cobra intake, stock cam, Vortech SC trim. 00' Lightning-Stock 88'CRX-13 second ego killer

08-14-2006, 10:59 PM	#27
68Falcon Bracket Racer Join Date: Apr 2003 Location: Loxahatchee, Florida Posts: 210	Re: I'm taking my Mustang to the track (any guesses on how Fast) I put jet extensors on it and bigger accelerator pump on it and played with the air mixture screws. __________________ Streetcar 90 Notch 69 351W .030 over. Untouched 69 351 heads Crane cams duration @050 216in 228ex. valve lift .484in .512ex. Untouched RPM air gap intake with Holley 750 DP. Hooker headers. C6 trans. 8.8 with 3.73, Strange 31spline alxes and spool Racecar 68 Falcon 10 point Cage and FE487ci 13.6:1 compression. .740 lift 276in 284ex duration @.050 in the Works. 428CJ heads. Port O Sonic intake with 1050 Dominator. PowerGlide trans.

08-14-2006, 11:19 PM	#28
82 GT Import Slayer Join Date: May 1999 Posts: 2,241	Re: I'm taking my Mustang to the track (any guesses on how Fast) I'm assuming you went from 30cc pumps to 50cc..? We have very similiar setups I'd like to get 12.6's out of mine too. What size PV are you running? __________________ '82 GT 351W (.060)Comp Cams 274* Extreme Energy cam, ported & polished heads w/ 1.94/1.60 valves 10.3:1 flat top pistons,stealth intake, Mallory dizzy,Holley 750dp carb, BBK shorties,Flowmaster exhaust,C-4 with 3700 stall converter, B&M pro shifter,8.8 rear, 4:10's, subframes, electric fan, powermaster alternator, 4 core radiator.

08-15-2006, 04:48 AM	#29
68Falcon Bracket Racer Join Date: Apr 2003 Location: Loxahatchee, Florida Posts: 210	Re: I'm taking my Mustang to the track (any guesses on how Fast) The Carb is stock beside what I did to it. I don't know what power valve is in it. The reason why I put the 50cc accelerator pump on it was for the Spray. __________________ Streetcar 90 Notch 69 351W .030 over. Untouched 69 351 heads Crane cams duration @050 216in 228ex. valve lift .484in .512ex. Untouched RPM air gap intake with Holley 750 DP. Hooker headers. C6 trans. 8.8 with 3.73, Strange 31spline alxes and spool Racecar 68 Falcon 10 point Cage and FE487ci 13.6:1 compression. .740 lift 276in 284ex duration @.050 in the Works. 428CJ heads. Port O Sonic intake with 1050 Dominator. PowerGlide trans.

08-15-2006, 05:29 PM	#30
Rev Registered Member Join Date: Nov 1998 Location: Houston, Tx. Posts: 3,887	Re: I'm taking my Mustang to the track (any guesses on how Fast) I had to put a 50 cc pump in my 625 Road Demon when I changed cam ( 218/218 to 224/230 @ .050) and to an Edelbrock Air Gap. I also had to open up the pvcr's some as well as open up the low speed air bleeds a little. Suprised me some to have to do all that to get rid of the lean bog and lean stumble at cruise speeds. Also had to play with the secondary vacuum springs some for best results. I don't think there's any end to the carb tuning one has to do when changes are made in other areas. Mine does have to remain streetable. Rev __________________ '66 Coupe, 306, 350-375 HP, C-4, 13.07 e.t., 104.8 mph, 1/4 mi. O.B.C. #2 '66 coupe Last edited by Rev; 08-15-2006 at 06:09 PM..

08-15-2006, 09:52 PM	#31
82 GT Import Slayer Join Date: May 1999 Posts: 2,241	Re: I'm taking my Mustang to the track (any guesses on how Fast) REV...what size converter do you have now and what are your 60' times? You just need a little more ummmmph to crack the 12's. I'd like to see your beast break the 12's too! When you do break the 12's, you'll be like me and wanting 11's then...LOL....but I'm going to "juice" my way into the 11's though..LOL __________________ '82 GT 351W (.060)Comp Cams 274* Extreme Energy cam, ported & polished heads w/ 1.94/1.60 valves 10.3:1 flat top pistons,stealth intake, Mallory dizzy,Holley 750dp carb, BBK shorties,Flowmaster exhaust,C-4 with 3700 stall converter, B&M pro shifter,8.8 rear, 4:10's, subframes, electric fan, powermaster alternator, 4 core radiator.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Going to the track tomorrow...guesses on what I'll run	82 GT	Windsor Power	3	08-07-2004 08:38 AM
need some advice on taking the weight of my mustang	Mustangboy89	Windsor Power	10	11-04-2002 05:43 AM
Fastlane Motorsports Mustang meet and show, Aug 11, Salina KS...	Garyput	Blue Oval Lounge	7	08-07-2001 10:44 PM
Help fast please gotta make it to the track "timing question"	Dark_5.0	Windsor Power	2	08-03-2001 09:59 PM
Fastlane Motorsports Mustang meet and show, Aug 11, Salina KS...	Garyput	Ford Show & Go	0	07-09-2001 05:31 PM