Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-05-2007, 11:00 AM
|
#1 |
|
Registered Member
Join Date: Mar 2004
Posts: 73
|
MAF conversion
Hey guys, i just finished my MAF conversion and i have a couple quesitons: First- the connector has ABCD on the harness, the Red is power the black is ground and then two signals-one positive and one negative, how do i know i have the correct one going to the correct pin location. It is still running bad. Also, would it make a difference in how it is running if i am running it at full advance with the spout connector out, or with it in and adjusting it from about 14 or so and finding the right spot? Shouldn't it run the best at full advance with the spout out?
thanks, |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 85 5 lug conversion | untamed351 | Windsor Power | 6 | 07-24-2009 02:42 PM |
| 5 lug conversion | tommythrasher32 | Corner Carvers Delight | 5 | 03-07-2005 03:15 PM |
| 2.3 conversion to 5.0 | cincykid71403 | Small Ponies | 4 | 01-15-2005 09:52 AM |
| conversion | tarmon8r | Windsor Power | 1 | 05-05-2004 08:51 AM |
| 351 Conversion... EFI, What do I have to use? | 1989_351W | Windsor Power | 1 | 02-26-2002 12:51 PM |