© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-04-2001, 08:51 AM | #1 |
Registered Member
Join Date: Dec 2000
Location: tuscumbia, Al.
Posts: 17
|
how do you clean connections
I'm using a used harness & computer for an engine swap that I'm doing. Have read about the problems caused by bad connections. What is the best way to clean the connections? should I use a dielectric grease on the connections?
|
01-04-2001, 11:28 AM | #2 |
Guest
Posts: n/a
|
Go to your auto parts store and they should have something called electrical parts cleaner. Spray it on there, then use compressed air to blow it out. Now just put some dielectric grease on the pins, or in the female end and connect it.
|
01-04-2001, 12:24 PM | #3 |
Registered Member
Join Date: Dec 2000
Location: tuscumbia, Al.
Posts: 17
|
Will it be ok to spray the cleaner in the computer connections?
|
01-05-2001, 03:06 PM | #4 |
Dirk Diggler
Join Date: Feb 1999
Location: SLOATSBURG, NY
Posts: 1,931
|
yes i highly recremend using dielctric grease on all ur connnections and spark plug wires..it will save ur connections in the long run(corrosion), and keep mosture out, while keeping the connections from getting stuck 2gether
------------------ 1987 black notch(ex 4 banger) DSS 306 w/ main support...Elderbrock 6028 heads..gt-40 intake..24# injectors...70 mm tb..77 pro-m...accel 300+..mac full legnth..tremec w/ pro5oh...full MAC exhaust,off road h-pipe,long tubes, catback...ron davis radiator..subframes, control arms...CFDF II..o yea holley FPR sucks..dont buy one.. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Clean your K&N! | ac97gt | Modular Madness | 5 | 08-29-2004 09:50 PM |
clean engine bay!! | pedley | Windsor Power | 0 | 01-03-2004 06:37 PM |
Can you CLEAN O2's | drtbiker | Windsor Power | 4 | 10-15-2002 08:06 PM |
Miracle clean for inside of polished Aluminum rims!! | Fox Body | Appearance & Detailing | 2 | 03-08-2001 06:42 PM |