Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-06-2005, 11:35 AM
|
#1 |
|
N-V-ME
Join Date: May 2005
Location: SOUTHFIELD,MICHIGAN
Posts: 155
|
302 Cam In A 351c Or M
Will A 302 Cam Fit In A 351c Or M Motor Hyd. Or Roller.......
__________________
88' LX MUSTANG: LINCOLN ROTORS , AIR SUSPENSION FRONT AND REAR, SUBFRAMES, ROLL CAGE, 92' BLOCK, MSD 6AL, ACCEL 8.8 WIRES, ACCEL COIL, EDELBROCK F4B INTAKE (PORTED),2 IN. 4 HOLE SPACERS, HOLLEY 600 CARB.,HOLLEY BLUE FUEL PUMP AN REGULATOR, E 303 (.498 IN. 220 DUR.) CAM, (.535 IN. OF LIFT W/ 1.72 SCORPIN ROLLER ROCKERS), PORTED E7'S, FLOWTECH 1 5/8 LONG TUBE HEADERS, 2 1/2 IN. H PIPE, 2 CHAMBER FLOWMASTERS WITH 3 IN.DUMPS, T-5, 3.73 GEARS, 5 LUG AEROSTAR AXELS, 245-45-17 96' COBRA WHEELS |
|
|
|
10-06-2005, 01:39 PM
|
#2 |
|
Rat Killer
Join Date: Aug 2002
Location: Cold ass Ohio
Posts: 1,143
|
Re: 302 Cam In A 351c Or M
Nope. Cleveland/M/400 take the same cam, and 302/351 Windsor take the same cam.
__________________
d-Con Racing "Nothing fancy, just 347 inches of RAT POISON!" MICE need not apply..... 
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 351W vs 351C | z3beemer | Classic Mustangs | 17 | 01-25-2006 11:13 PM |
| 351c, 390 Motors | Fat0eknee | Classic Mustangs | 5 | 04-10-2005 01:27 AM |
| Could I use 71 351C valvesprings on my e7's? | crazypete | Windsor Power | 1 | 07-15-2004 10:43 AM |
| 1970 351C 4bbl low plane 2x4 intake | jwmustangin | Classic Mustangs | 3 | 04-17-2002 01:27 PM |
| Is it worth it 351C to 460 | ASMO | Classic Mustangs | 0 | 04-09-2001 05:37 AM |