Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-23-2002, 08:55 PM
|
#1 |
|
Registered Member
Join Date: May 2001
Location: baytown,tx,us
Posts: 128
|
trick flows
what is the largest size cam can trick flow heads take out of the box. i know the dur is 290
|
|
|
|
07-23-2002, 09:11 PM
|
#2 |
|
Registered Member
Join Date: May 1999
Location: Georgia
Posts: 3,866
|
that info. is on thier website. Look it up there
|
|
|
|
|
07-23-2002, 10:03 PM
|
#3 |
|
I need 110mph Trap Speed!
Join Date: Feb 1999
Location: So, CA
Posts: 4,315
|
.540 lift
__________________
2001 BMW M3 6spd 12.79@108 RIP ---- 1993 Notch w/ 98 4V 4.6 Fasttt... -1989 Saleen Mustang #406- 12.32@109 -1999 Black Cobra Coupe- JBA Shorties, Bassani Cat-X, Magnaflow 3", Pulleys, 85mm Pro-M, Ported Intake, Soild Rear w/ 4.30s, Tubular Front End, X2C arms, 13lb batt, few others. |
|
|
|
|
07-24-2002, 10:56 AM
|
#4 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
The twisted wedge heads will take .540
The track heat and high port will take .600
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Trick Flow intake problems | shacar87 | Windsor Power | 9 | 11-14-2003 05:53 PM |
| Trick Flow Manifold Install | squid | Windsor Power | 1 | 11-09-2002 06:24 PM |
| modifying flows | rppngears | Windsor Power | 1 | 09-09-2002 02:40 PM |
| Hey Stoplight Warrior!!!!!! Did you try the Resistor Trick yet?? | Mercury | Modular Madness | 0 | 11-10-2001 03:31 PM |
| A Really sweet trick for mustangs 99 and up | MBC50403 | Small Ponies | 0 | 08-17-2001 01:02 PM |