MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Register FAQ Members List Calendar

Notices


Reply
 
Thread Tools Rate Thread Display Modes
Old 01-09-2004, 02:08 AM   #1
88GT 5pt0
Registered Member
 
Join Date: Jun 2003
Location: Chicago
Posts: 73
Default Did a tune up, but something's not right

When i changed the wires I did them one at a time and made sure the new ones were the same lenght as the old ones. When I got to the last one it was the plug furtest from the cap on the right side. The only wire I had left was much shorter then this one, it wouldnt even reach. So not knowing where I went wrong I had to rearange the wires till they all fit. Now my car is running really rough when I accelerate up till about 2100-2200 rpm then its not that bad. it is also idling at 800-900 which is 100-200 higher than before. Did I mess up or did they give me the wrong set of plugs? If I take them back for new ones I need to know the right order they go in
__________________
My Cardomain Website
88GT 5pt0 is offline   Reply With Quote
Old 01-09-2004, 08:09 AM   #2
BLACK85GT
Registered Member
 
BLACK85GT's Avatar
 
Join Date: May 2002
Location: Tampa,FLORIDA
Posts: 340
Default

Yeah, you just crossed a wire somewhere. If you have a chiltons manual or any ford manual, it tells you the correct firing order. I am shure some one here remembers it, but a book for 10 bucks gives you all the details...
__________________
5.0, Holley heads, 1.7 Scorp Rockers, Stealth intake, Holley 600 carb, Holley Mech. Fuel pump, MSD 6Digital, MSD distributor, Hotchkis upper/lower rear control arms, FMS B Springs, 3:73 (8.8) rear.
Production # 9,377
BLACK85GT is offline   Reply With Quote
Old 01-09-2004, 11:22 AM   #3
Fox Body
Mustang Maniac
 
Fox Body's Avatar
 
Join Date: Sep 2000
Location: GA, U.S.A
Posts: 2,266
Default

1) Firing order for your car is 13726548.

2) Your 5.0's distributor turns counterclockwise.

3) The #s on the cylinders read like this: standing in front of the car facing the engine, on passenger side of vehicle starting at left side, closest to you (farthest from firewall) is # 1, then going back toward the firewall is #2, then #3, #4. Then starting on right side (driver's side) closest to you is 5, then going back toward firewall, #6, #7, #8.

So with this information you can make sure you have the correct arrangement of plugs (firing order).

For example, looking at the distributor cap, you can see a "1" on the top. Starting from "1" on the cap, circle like a clock, but counterclockwise and the next is 2 (not read), then all the way to 8 notches. Match them up to the motor in the correct way using the info above.

As far as a shorter plug wire. Just about everytime I've gone to get new plugs for my Mustangs (whether the '92 or the '79, the coil wire in the box is wrong (too short), but the rest are right, and many times I've just left the old coil wire on there....

Also, make sure you check that you didn't knock off any vacuum hoses (coming from your intake or anywhere else) or that none of your hoses are corroded or old and weak b/c a rough idle is sometime indicative of bad vacuum, but REALLY rough idle in your case is more likely messed up fireing order, but you may only have 2 crossed if any, b/c if it were more than that, the car would barely run right, which doesn't seem like your situation.
__________________
351W-powered 1979 Ford Mustang Ghia notchback
'79 Video @ Idle
Stock 5.8L under 4" cowl 'glass hood, C4 w/ Transgo shift kit, Holley 750 cfm, Edelbrock Performer RPM intake; Fluidyne Al radiator, Flexalite 175 electric fan, 1 5/8" MAC shorty headers, FRPP Al driveshaft; S&W 6-point cage; 2.5" Off road H-pipe, 2-chamber Flowmasters, 8.8" Rear w/ 3.55s; Weld wheels (15x6;15x8), Front: 225/60/15, Rear: 275/50/15 Nitto NT 555R Drag Radials;
14 x 4” K&N X-stream air filter.


'92 GT (5-speed)
Small In Car Video
Stock 5.0L, 2-chamber Flowmasters, MAC CAI, Tri-Ax, Al pedals...

"Red, thou art my companion. Hasten now your quickened metamorphosis to Green that I may conquer all who dare abide there beside me. May they be left thither behind burnt black." ---Fox Body
Fox Body is offline   Reply With Quote
Old 01-09-2004, 11:28 AM   #4
Fox Body
Mustang Maniac
 
Fox Body's Avatar
 
Join Date: Sep 2000
Location: GA, U.S.A
Posts: 2,266
Default

BTW, my experience has been that if it idles higher rpm, it's more a vacuum leak, but running lower , sounding like trying to die and maybe even backfiring is more due to screwed up firing order.
__________________
351W-powered 1979 Ford Mustang Ghia notchback
'79 Video @ Idle
Stock 5.8L under 4" cowl 'glass hood, C4 w/ Transgo shift kit, Holley 750 cfm, Edelbrock Performer RPM intake; Fluidyne Al radiator, Flexalite 175 electric fan, 1 5/8" MAC shorty headers, FRPP Al driveshaft; S&W 6-point cage; 2.5" Off road H-pipe, 2-chamber Flowmasters, 8.8" Rear w/ 3.55s; Weld wheels (15x6;15x8), Front: 225/60/15, Rear: 275/50/15 Nitto NT 555R Drag Radials;
14 x 4” K&N X-stream air filter.


'92 GT (5-speed)
Small In Car Video
Stock 5.0L, 2-chamber Flowmasters, MAC CAI, Tri-Ax, Al pedals...

"Red, thou art my companion. Hasten now your quickened metamorphosis to Green that I may conquer all who dare abide there beside me. May they be left thither behind burnt black." ---Fox Body
Fox Body is offline   Reply With Quote
Old 01-11-2004, 05:49 AM   #5
88GT 5pt0
Registered Member
 
Join Date: Jun 2003
Location: Chicago
Posts: 73
Default

as it turns out, I'm retarded and didnt notice one of the boots got disconnected from the plug. its running fine now. thanks
__________________
My Cardomain Website
88GT 5pt0 is offline   Reply With Quote
Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Question about tune up JellyBean Small Ponies 6 05-19-2003 04:18 PM
Tune Edlebrock Performer Carb? 7000rpmisheaven Classic Mustangs 2 05-18-2002 08:25 PM
Quick Question about a Tune Up xspeed02 Windsor Power 4 03-28-2001 02:08 PM
Private test and tune session at Darlington Dragway in SC TurboV6 Blue Oval Lounge 3 02-12-2001 11:19 PM
Private test and tune session at Darlington Dragway in SC TurboV6 Racer's Club House 0 02-06-2001 03:27 PM


All times are GMT -5. The time now is 04:25 AM.


SEARCH