© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-17-2001, 09:39 PM | #1 |
Registered Member
Join Date: Apr 1999
Location: belleville IL.
Posts: 60
|
Header vibration on K-Member
Well I have BBK Equal length headers and one of the tubes on the pass. side is vibrating lightly on the K-Member. I have new motor mounts that I installed the same time I did the headers, I was wondering if there was any reason I could'nt just put a hardend thick washer "spacer" of some sort between the mount and the block on the pass. side All I would need is less than a 1/8". the car had been hit in the right front corner before I bought it so I dont now the extent, but it tracks straight and the body lines all line up so I think every thing is O.K. THanks for any input.
------------------ 1990 spec. serv. coupe w/aod, b-303, gt-40 heads and intake, 1.6rr, 1" spacer, fms valve covers, mac cold air intake, bbk equil shorties, under drives, 65mm t.b. 2.5" flows, fms 9mm wires, |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
K Member | 65,dohc,project | Classic Mustangs | 0 | 10-06-2004 03:27 PM |
Vibration Problem | RDMumfts Stang | Windsor Power | 10 | 03-23-2003 07:04 PM |
Header and Exhaust Installation | 1991GT | Windsor Power | 4 | 12-03-2002 11:17 PM |
Vibration thru vehicle when accelerator is pressed | race1now | Windsor Power | 1 | 01-22-2001 12:28 AM |