MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Register FAQ Members List Calendar

Notices


Reply
 
Thread Tools Rate Thread Display Modes
Old 07-02-2003, 10:33 AM   #1
Bad89stang
Registered Member
 
Bad89stang's Avatar
 
Join Date: Aug 2001
Location: Ft. Worth, TX
Posts: 456
Default TFI questions

Well, I have done extensive searches on the TFI subject to see if that is possibly my problem, but it does not match up completely.

My car completely cuts out once it starts to get warm and then gets worse progressively. The voltmeter stays constant so I don't think it is a ground or 12V source coming loose. The motor DOES NOT DIE, but simply looses total power as if turning off a light switch and then back on a split second later. Could this be ignition related? I have a Crane HI6 box that has only been installed for 5 months, but the test light shows that it is fine.

I have swapped the coil for another just to test and that was not it.

I had the TFI tested at Autozone and it tested good. He got it plenty warm to simulate driving for awhile.

I am stumped.
__________________
You're gonna need your seatbelt
Bad89stang is offline   Reply With Quote
Old 07-02-2003, 10:55 AM   #2
LX XLR8R
Dirk Diggler
 
Join Date: Feb 1999
Location: SLOATSBURG, NY
Posts: 1,931
Default

sounds more like fuel pressure..how is your pump..if it was the TFI then it will do one of 2 things...run lean up top, or car will die and not run till let sit for a while..both have happened to me..the one where it dies and wont start is a very common problem but my car once actally ran real real lean upstairs to the point of fuel starvation cut out..it turned out that the TFI module also controls something with the fuel..never looked into how exaclty becasue when i swapped mine out my car ran like a rapped ape and i didnt care anymore
__________________
95 undecided cubes, AFR 185s,undecided cam, undecided intake, and a 150 hit
89 "turbonotch" 2.3T

You might want to hold on..i saw this on a cartoon once
LX XLR8R is offline   Reply With Quote
Old 07-02-2003, 11:06 AM   #3
Bad89stang
Registered Member
 
Bad89stang's Avatar
 
Join Date: Aug 2001
Location: Ft. Worth, TX
Posts: 456
Default

Fuel pressure looks fine. I can only check it idle with the gauge that is under the hood. I can't test the lean up top part because if it were to cut out like that at WOT or high speeds it would be very hard on the car/drivetrain.
__________________
You're gonna need your seatbelt
Bad89stang is offline   Reply With Quote
Old 07-02-2003, 12:20 PM   #4
LX XLR8R
Dirk Diggler
 
Join Date: Feb 1999
Location: SLOATSBURG, NY
Posts: 1,931
Default

check to make sure your positive cable isnt shorting out anywhere also
__________________
95 undecided cubes, AFR 185s,undecided cam, undecided intake, and a 150 hit
89 "turbonotch" 2.3T

You might want to hold on..i saw this on a cartoon once
LX XLR8R is offline   Reply With Quote
Old 07-02-2003, 12:22 PM   #5
Bad89stang
Registered Member
 
Bad89stang's Avatar
 
Join Date: Aug 2001
Location: Ft. Worth, TX
Posts: 456
Default

Voltmeter does not fluctuate as stated above. The battery is in the trunk and the 00 gauge welding cable could probably outlast a car fire. Very well mounted and hooked up. Thanks for idea though.
__________________
You're gonna need your seatbelt
Bad89stang is offline   Reply With Quote
Old 07-02-2003, 01:08 PM   #6
LX XLR8R
Dirk Diggler
 
Join Date: Feb 1999
Location: SLOATSBURG, NY
Posts: 1,931
Default

yea i used welding cable on all my trunk installs..works the best..it sure does sound like what happened when my positive terminal was grounding out when my battery was loose in the trunk..other than that im kinda stumped becasue it happes when the car warms up witch usually indicated TFI/fuel pump..yo got me thinking
__________________
95 undecided cubes, AFR 185s,undecided cam, undecided intake, and a 150 hit
89 "turbonotch" 2.3T

You might want to hold on..i saw this on a cartoon once
LX XLR8R is offline   Reply With Quote
Old 07-02-2003, 01:11 PM   #7
Bad89stang
Registered Member
 
Bad89stang's Avatar
 
Join Date: Aug 2001
Location: Ft. Worth, TX
Posts: 456
Default

I am going to switch out my TFI for another one before I go out and buy one. Just to make sure.
__________________
You're gonna need your seatbelt
Bad89stang is offline   Reply With Quote
Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Just got a 98, have some questions? 98GTNewbie Modular Madness 5 08-30-2003 12:41 AM
Quick questions on Explorer Intake install. Falcons Talon Windsor Power 2 08-21-2003 12:40 PM
Several questions about oil. zepherman Windsor Power 3 08-03-2002 06:59 AM
HELP! Newbie 95-96 GT questions Ron Brooks Blue Oval Lounge 7 07-11-2001 07:38 PM
S/R Questions DAMION Racer's Club House 1 09-30-1999 11:02 AM


All times are GMT -5. The time now is 11:34 AM.


SEARCH